LW Plastic Slat
LW-series PP slat floor with wide drainage gaps and a saw-tooth anti-slip face, made in spans from 200 to 600 mm.
PP / HDPE600×400 / 600×500 / 600×600 mm
Product range
All 39 Products Across Nine Systems
Every catalogued product, grouped by system, with model codes and sizes on each product page. Nothing here is a placeholder — if a figure is not in our catalogue, the page says so.
Flooring & Structure
Slatted Floors
Plastic and cast-iron slatted flooring for farrowing, nursery and finishing rooms — engineered for drainage, grip and a long life under washdown.
LWD Fine-Gap Plastic Slat
LWD-series slat with a finer drainage gap and a denser rib pattern that protects piglet feet while keeping the pen dry.
PP600×400 to 600×700 mm
Waterdrop (LWS) Plastic Slat
Waterdrop-pattern LWS slat with rounded holes for fast drainage and quick washdown in farrowing and nursery rooms.
PP600×300 to 600×600 mm
Cast Iron Slat
Ductile cast-iron slat insert for the dunging area, where the floor takes the most weight and the most wear.
Ductile cast ironHot-dip / coated
Flooring & Structure
PVC Wall Panel & Board
Hollow PVC wall and partition boards — sealed, washable surfaces that replace block and render in modern animal housing.
PVC Hollow Wall Board
Sealed-chamber PVC wall board that replaces block-and-render walls with a wipe-clean, moisture-proof surface.
Rigid PVC500×750 mm + sizes
PVC Panel (Herringbone Rib)
Herringbone-ribbed PVC panel that stays flat across a wide pen face where a straight-rib board would flex.
Rigid PVC500–800 × 350 mm
PVC Co-Extruded Panel
Co-extruded PVC panel with a heavier wall and a bonded sealing strip on the joining edge for impact positions.
Co-extruded PVC600×350 mm
PVC Hollow Board
The straight-rib PVC hollow board range — the everyday board for pen partitions, dividers and bench tops.
Rigid PVC500×350 mm + sizes
Flooring & Structure
FRP Support Beams
Fibreglass support and bearing beams that carry plastic and cast-iron slats across the pit and never corrode doing it.
FRP T-Beam Support
Pultruded fibreglass T-beam that carries plastic and cast-iron slats across the manure pit and does not corrode doing it.
FRP compositeT-profile
FRP I-Beam Support
Fibreglass I-profile support for the wide slat spans used in grow-finish and gestation rooms.
FRP compositeI-profile
FRP Channel Beam
Channel and special-profile fibreglass sections for perimeter support, edge runs and positions a plain T will not reach.
FRP compositeChannel profile
FRP Beam with Bracket
Triangular fibreglass support supplied with moulded feet, so a beam line can be set level without site fabrication.
FRP + bracketsPre-set feet
Penning
Pig PP Panel
Polypropylene pen panels in green, black and white — solid and vented faces, smooth, impact-resistant and sized from 850 to 1200 mm.
Pig PP Panel (Colour Range)
The full PP pen panel range — four sizes, five colours, solid or vented faces, in standard and reinforced grades.
Polypropylene (PP)Green / black / white
Pig PP Panel — Green
Green PP pen panel in the 900 and 850 mm heights — the most common pen wall and gate face in a weaner room.
Polypropylene (PP)1000×900 / 850×50 mm
Pig PP Panel — Black
Black PP pen panel in the tall 1200 × 1000 × 50 mm size, for the positions that take the most light and the most wear.
Polypropylene (PP)1200×1000×50 mm
Penning
Pen Partitions & Penning
Partition panels and penning components for farrowing crates, weaner pens and grow-finish rooms — built to keep groups apart and pens dry.
PP Partition Panels
PP partition panels sold as pen dividers — slotted for airflow, smooth-faced for washdown, in the heights each stage needs.
Polypropylene (PP)Vented + solid faces
PVC Partition Panel (Vented)
Slotted PVC partition panel that divides pens while keeping air moving between them.
PVCVented slots
Reinforced Partition Panel
Steel-framed partition panel for the gates and high-traffic positions where a plain panel is not enough.
Steel-framedHeavy-duty
Solid Partition Panel
Solid-face partition that fully separates two groups, for the room boundaries where biosecurity comes before airflow.
PVC / FRPSolid face
Partition Panel System
The complete panel-and-post system: panels, posts, brackets and connectors quoted as one pen layout rather than as parts.
ModularBracket-mounted
Farrowing / Weaner Penning
Integrated farrowing and weaner penning, engineered around the flooring and feeders that go in the same room.
TurnkeyGalvanised + plastic
Feeding & Drinking
Feeding Systems
Pan feeders, dosing cups, drop hoppers and trumpet pipes for accurate, low-waste feeding from weaning to finishing.
Maxi Pan Feeder
Large-capacity pan feeder with a stainless adjustment for grow-finish pigs, set to deliver feed without spilling it.
PP + stainlessAdjustable flow
Round Pan Feeder
Round wean-to-finish pan feeder that gives every pig the same access around the bowl.
PPWean-to-finish
Dosing Cup (6L / 8L)
Volumetric dosing cup in 6 L and 8 L that sets an exact ration per sow and drops it on command.
6 L / 8 LVolumetric dose
Transparent Dosing Cup
Clear-body dosing cup in 6 L and 8 L, so the set ration can be checked at a glance before the drop.
Transparent bodyVolumetric
Feed Drop Hopper
Drop hopper that channels feed cleanly from the line into the pan or trough below.
PPAnti-bridge
Trumpet Feed Drop Pipe
Trumpet-mouth drop pipe in Ø60 and Ø75 mm that spreads feed evenly across the pan instead of dropping it in one place.
PPØ60 / Ø75
Feeding & Drinking
Drinking Systems
Drinking bowls, cups and water-control valves that keep clean water flowing at the right pressure for every animal stage.
Drinking Bowl
Robust drinker bowl with a float valve, so water is there when the animal wants it and nowhere else.
Cast + stainlessFloat valve
Drinking Cup
Bite-action drinking cup that delivers water only while the animal is drinking, and stays clean between.
Engineering plasticBite valve
Piglet Drinking Cup
Low-flow piglet cup sized for creep and nursery pens, with a transparent bowl so intake can be seen.
PlasticLow flow
Water Control Valve
Diaphragm water control valve that holds the right pressure to bowls and nipple lines, all day and every day.
Diaphragm valveRegulated
Climate & Parts
Climate & Ventilation
Recirculation fans and impellers that even out temperature and air quality across farrowing and nursery rooms.
Recirculation Fan
Recirculation fan that mixes room air so the temperature at the far pen matches the temperature at the controller.
Sealed housingWashable
Recirculation Fan (Compact)
Compact recirculation fan for spot air movement where a full-size unit will not fit.
CompactCorrosion-resistant
Fan Impeller
Balanced replacement impeller, so a damaged blade does not mean buying a new fan.
Balanced bladeReplacement part
Climate & Parts
PVC Profiles & Connectors
PVC connecting profiles that lock panels and posts into a sealed, flush penning system — H, L, U, corner post and tube sections.
PVC H-Connector
H-section profile that joins two panels into one continuous, flush wall run with no visible fixings.
PVC extrusionH-joint
PVC U-Channel
Edge and base U-channel that locks panels in place and closes the joint where a wall meets the floor.
PVC extrusionU-channel
PVC L-Profile
L-section trim that finishes a panel edge at an opening or an external corner.
PVC extrusionL-profile
PVC Corner Post
Corner and junction posts that tie panels together wherever a pen changes direction.
PVC extrusion4-way post
PVC Square Tube
Square-section PVC tube for the top rails and frame members that finish a penning run.
PVC extrusion35×35 mm
Answers
Questions About The Range
How many products does JGM manufacture?
This page lists all 39 catalogued products across nine systems. Sizes and colours within each product are produced to customer requirement.
Can I order a single product or must I buy a system?
Either. Many customers start with flooring and feeding and add penning and climate later; the systems are designed to be added to.
Where do the model codes come from?
From the JGM product catalogue, which is downloadable as a PDF from this site and carries sizes, colours and carton-loading data.
Do you accept OEM and custom specifications?
Yes — sizes, colours and configurations are produced to customer requirement, and OEM orders are accepted.
Talk to an engineer
Not sure which products your rooms need
Send room dimensions, animal stages and target capacity. Our engineers return an equipment list with model codes, not a catalogue.