Knowledge Center
15 Guides Written by the People Who Make the Material
Selection installation materials comparisons and troubleshooting. Every guide links to the products it discusses so you can go straight from the answer to the part number.
5 Articles
Selection Guides
How to Select a Heat Shrink Cable Termination Kit
Five pieces of cable data decide the part number and four of them are printed on the cable
READ →
Medium Wall Versus Heavy Wall Heat Shrink Tubing
When the extra wall thickness earns its cost and when it is money spent on stiffness you do not want
READ →
Busbar Insulation in Compact Switchgear
What insulated bar actually achieves what it does not and how to handle the joints
READ →
How Many Rain Sheds Does an Outdoor Termination Need
Pollution class not voltage alone decides the count and the default is usually too low
READ →
Shrink Ratio and Sizing Guide for Heat Shrink Tubing
How to read D and d, when 2:1 is not enough and the two measurements that decide everything
READ →4 Articles
Installation Guides
How to Insulate a Bolted Busbar Joint
Why tube does not work what to measure and how to keep the joint inspectable
READ →
Emergency Cable Jacket Repair Guide
How to decide whether a cable can be repaired and how to make the repair last
READ →
How to Seal a Cut Cable End
Why water wicks metres along a conductor and the twenty minute job that prevents it
READ →
Installing Heat Shrink Accessories in Cold Weather
What changes below zero what does not and the two mistakes that cold weather encourages
READ →3 Articles
Material Guides
Stress Control Materials Explained
High permittivity grading zinc oxide non linear resistance and geometric stress cones compared
READ →
Halogen Free Versus Flame Retardant Heat Shrink Tubing
Two different requirements that specifications often confuse and how to choose between them
READ →
Storage and Shelf Life of Heat Shrink Cable Accessory Kits
Five years in the right conditions and what actually degrades when the conditions are wrong
READ →2 Articles
Comparison Articles
Heat Shrink Versus Cold Shrink Terminations
An honest comparison of cost size range installation and the conditions where each one wins
READ →
Raychem Cross Reference Guide for Power Cable Accessories
Which UPM part corresponds to which TE Raychem part and how to verify before substituting
READ →
FAQ
About These Guides
How often are these guides updated
Can I use these guides in my own method statements
Do you offer training
What if my question is not covered
Still need an answer ask our engineers on WhatsApp
Ask an Engineer Directly
There is no form on this site. Technical questions go straight to the people who make the material.