6 boards in this category
Sequential lamination decides which nets can be routed at all. These structures are released for mass production, not just prototype runs.
Ranges below are computed from the 6 boards listed on this page, not from a marketing sheet.
| Built to | Range across this category |
|---|---|
| Layer counts built | 4–16 |
| Base materials | FR4 IT180A, FR4 IT180A+PI, FR4 S1000-2M, FR4 TG150, FR4 TG170 |
| Surface finishes | ENIG 1u, ENIG 2u, ENIG 3u, ENTEK (OSP) |
| Solder mask colours | Black, Blue, Green, Matte Black |
| Finished thickness | 1.2–2.8 mm |
Send Gerber plus a drill file and a stack-up note. Quotation comes back within 6 hours, with DFM comments attached.
