3 boards in this category
These are the processes that normally force a customer to split a job across two suppliers. They run on our own lines, on the same panel.
Ranges below are computed from the 3 boards listed on this page, not from a marketing sheet.
| Built to | Range across this category |
|---|---|
| Layer counts built | 10–18 |
| Base materials | FR4 IT180A, FR4 TG170 |
| Surface finishes | ENIG 1u, ENIG 2u, HASL Lead-Free |
| Solder mask colours | Green |
| Special processes | POFV & Backdrill |
| Finished thickness | 2.0–3.6 mm |
Send Gerber plus a drill file and a stack-up note. Quotation comes back within 6 hours, with DFM comments attached.
