DK-04
Device Assembly and Inspection Systems
Assembly and inspection equipment for regulated device production
Equipment in This Group
All 3 Machines in This Group
Device manufacturing carries a documentation burden that general industrial automation does not. These systems assemble and inspect the device, and produce the evidence that each unit was built and checked the way the specification says.
Device Assembly Systems
Safety Device Assembly Systems
Assembly and test systems for devices where every unit must be proved before it ships
View equipment
Device Assembly Systems
Combination Device Assembly
Multi station systems that bring several assembly processes into one controlled cycle
View equipment
Device Assembly Systems
Diagnostic Device Automation
Automated assembly and inspection for diagnostic devices with a record for every unit
View equipmentThe Problem This Group Addresses
What Goes Wrong Without It
When a device has to be validated, an undocumented machine is a liability. Delkotech builds equipment designed to operate in mass production and to be validated to current regulatory standards, with the drawings, sequence of operation and test records supplied as part of the build.
- Machines built to the part, not to a catalogue envelope
- Sequence of operation written before any code
- Safety and guarding laid out with the machine
- Rate proved with your parts before shipment
- As built drawings and test records at handover
Where It Is Used
Industries Running This Equipment
Industry
Automotive Parts Manufacturing
Repeatable assembly and handling for automotive component production
See applicationsIndustry
Food Processing
Handling packaging and process automation built for a food production environment
See applicationsIndustry
Sheet Metal Fabrication
Feeding joining and handling equipment for flat sheet and panel production
See applicationsRelated
Projects From This Group
Project
Back Panel Clinching Machine
Cold formed joints on pre-finished back panels with no damage to the coating
Read the projectProject
Chakri Production Line
A complete production line integrating several processes under one control system
Read the projectProject
Isolation Cutting Machine
Cutting and handling unit built for an aluminium profile production environment
Read the projectQuestions
About Device Assembly and Inspection Systems
What is in the Device Assembly Systems group?
3 machine families: Safety Device Assembly Systems, Combination Device Assembly, Diagnostic Device Automation. Each is built to order around your part.
Which of these should I be looking at?
When a device has to be validated, an undocumented machine is a liability. If you describe the step that is causing trouble we will point you at the right machine rather than the largest one.
Can these machines be integrated with equipment we already own?
Yes. Give us the make, model and available signals of the equipment either side and the handshake is designed in from the start.
Why are the specifications marked TBC?
Because these are machines built to order. Travels, forces and cycle times are set against your part at design review and then measured and recorded before shipment. Publishing a number before that point would be guesswork.
How long does a machine in this group take to build?
Lead time depends on the configuration and the current build schedule at the Vaughan facility. Email [email protected] with your requirement and target date and we will give you a schedule.
Talk to an engineer
Bring Us the Operation, Not the Machine
Send the part drawing and describe the step. We will come back with a concept, a layout and a defined scope.