Skip to content
Reply within 24 hours · Despatch within 7 days
Yehang Stenter Parts Request A Quote
Bruckner Stenter Spare Parts for stenter machines
16 parts in this category

Bruckner Stenter Spare Parts

Bruckner frames are among the most widely installed German stenters, and like Monforts they have used more than one geometry across their generations. We hold three clip variants and three chain builds so most frames are matched from standing production.

Request A Quote See All 16 Parts
The Range

Every Bruckner Stenter Spare Parts We Make

Three clip variants, three chain builds, two pin plate profiles and both brush wheel sizes for Bruckner frames.

The Problem

Why This Category Exists

A Bruckner clip or chain that is close but not right does not fail obviously. It binds, or fails to close fully, and the symptom is dropped cloth rather than a mechanical fault. That makes it slow to diagnose and expensive in scrapped production.

Who This Is For

  • Mills running Bruckner frames as primary or secondary stenter capacity
  • Maintenance engineers who have received wrong parts ordered from a model number
  • Plants with two Bruckner machines that turn out to need different spares

Problems It Solves

  • Clips binding or failing to close because the geometry is slightly wrong
  • Chain elongation pulling the pin bed out of register
  • Pin plates failing early because the holder seats had already worn
Core Advantages

What You Get From This Range

  • Three Bruckner clip variants held, matched from your sample clip
  • Three Bruckner chain builds plus a lubrication version for greased guide frames
  • Two pin plate seat profiles, supplied loose or assembled into holders
  • Complete clip chain sections and pin plate chain sections, assembled and cycle tested before despatch
  • Brush wheels in 220 by 158 and 155 by 85
  • PEEK bushes and dust covers available as a chain upgrade
Applications

Industries Using These Parts

Woven Fabric FinishingTechnical Textiles and CoatingHome TextilesDenim Finishing
FAQ

Questions About Bruckner Stenter Spare Parts

How do I know which Bruckner variant I need?

Send one clip, one pin plate or a short length of chain. We identify the variant, record it against your account, and future orders go by reference.

What if none of your variants fits?

We reverse engineer from your sample. That is routine work and the specification is then recorded permanently.

Can you supply clips already mounted on chain?

Yes. Clip chain sections are assembled and cycle tested in our factory, which removes almost all of the on-machine work during a shutdown.

Lubricated or oil-free chain, which do I need?

It depends on the frame. Look at whether the design provides grease points at the chain interfaces, or send photographs and we will advise.

Do you supply Bruckner brush wheels?

Yes, at 220 by 158 and 155 by 85, with PP, nylon, pig hair and hard glued bristle options.

Lead time?

Within 7 days for standard items; sections and cut-to-sample work confirmed at quotation.

Related

Other Categories

Artos Stenter Spare Parts

Chains with copper or PEEK sliders, PEEK bushes, two pin plate profiles, clips and 205 by 145 brush wheels.

LK Stenter Spare Parts

Guide rail, chain, chain parts, 76 mm pin plate holders, pin plates, brush wheels and high temperature chain oil.

Send A Sample And We Will Match It

One part per machine is enough. We identify the profile, record it against your account, and repeat orders are placed by reference.

Chat on WhatsApp Email Us