Process GuideWhat Is a Stenter Machine and How Does It Work
The stenter heat-sets and dries fabric by stretching it to width and holding it there under controlled heat.
Read Article
Knowledge Centre
Guides On Stenter Machines Parts and Maintenance
Twelve articles covering how a stenter works, which parts wear, how to choose between pin and clip, why PEEK replaced metal at the wear interfaces, and how to buy machinery spares from China without the usual mistakes.
Process Guide
Product GuideKey Parts of a Stenter Machine
Entry section, clip or pin chains, rails, heating chambers, exhaust, blowers, temperature control, width adjustment and weft straightener.
Read Article
Comparison ArticlePin Stenter or Clip Stenter Which To Use
Clips leave no pin marks and suit thicker fabrics; pins hold more tension and run faster, to 100 m per minute.
Read Article
Material GuideWhy PEEK Replaced Metal In Stenter Wear Parts
Self-lubrication, high temperature resistance and low noise are why PEEK took over the wear interfaces.
Read Article
Maintenance GuideStenter Chain Maintenance and Lubrication
Clean the guide and chain at least once a year, use a high temperature grease, and gauge the pitch to decide service against replacement.
Read Article
Buying GuideHow To Choose a Brush Wheel For Your Stenter
Two decisions matter: the size, which differs by millimetres between brands, and the bristle, which follows the position temperature.
Read Article
Product GuideSelvedge Uncurlers Explained Mechanical Pneumatic and Roller Types
Mechanical types use physical contact, pneumatic types are contactless, and roller types come in two, three and four finger designs.
Read Article
Industry ArticleMonforts Stenter Machines and Their Key Features
TwinAir, ECO Booster, integrated chamber technology and a horizontal chain system, and what each one means for wear parts.
Read Article
Industry ArticleArtos Stenter Frames and What They Are Used For
Drying, heat-setting, stretching and finishing on cotton, polyester, nylon and other textiles requiring precise treatment.
Read Article
Industry ArticleThe Main Stenter Machine Brands and Where They Are Built
Bruckner, Monforts, LK, IL SUNG, Mamata, Harish, Babcock, Shaoyang, Artos, Stentex and Unitech.
Read Article
Buying GuideHow To Find a Reliable Factory In China
Research, credentials, a factory visit, references, samples and a clear contract, in that order.
Read Article
Buying GuideImporting Machinery Parts From China Step By Step
Identify the part, find the supplier, negotiate terms, arrange shipping, pay securely and clear customs.
Read ArticleFAQ
About These Guides
Who writes these guides?
They are written from the technical material on our own product pages and from what customers ask us. Where a figure appears, such as 5 mm pins or 100 m per minute, it comes from the parts we make rather than from a general reference.
Can I use this material in my own maintenance documents?
Yes. If it helps your engineers specify the right part, use it. Ask us if you want a specific figure confirmed for your machine.
What should I read first?
If you are new to stenters, start with what a stenter machine is and how it works. If you are choosing between pin and clip, read the comparison. If you are planning a shutdown, read the chain maintenance guide.
Do you cover brands you do not sell parts for?
The brand articles cover the main stenter makers, including ones we do not currently make parts for. Send a sample if you need a part for one of them and we will say honestly whether it is within our range.
Have A Question These Guides Do Not Answer
Send it with a photo of the part or the machine. Our team replies within 24 hours, and the answer often becomes the next article.