Every machine we build, grouped by discipline and listed in full. No pagination and nothing held back for an enquiry. Specifications come from the machine data sheets.
Flat, parallel and square, held across a full table load. A surface grinder earns its place when the parts leaving it need no further flatting. WUK builds three table sizes on the same heavy cast iron column, from the hydraulic MY3060 through to the servo controlled 4080AHD, so
A 300 x 600 mm hydraulic surface grinder for small and medium parts in tool rooms and production plants.
Servo vertical feed and hydraulic table traverse on a 300 x 600 mm table.
The largest table in the WUK surface grinding range, at 400 x 800 mm with 950 mm of X travel.
Round, straight and concentric on the same setup. Cylindrical grinding is where concentricity is either won or lost. Our universal machines carry both an outside diameter wheel head and a high speed internal spindle, so a bush can be ground on the bore and the outside w
OD and ID grinding on one machine, for shafts, bushes, needle valves and plungers.
CNC punch and pin grinding from 1 mm up to 150 mm, internal and external.
The larger centerless machine in the range, covering 0.5 to 60 mm diameter.
Built for small parts, where high volume and tight size control meet.
No chucking, no centres, no part to part setup time. Centerless grinding wins on volume. Once the blade height and regulating wheel angle are set, parts feed through continuously and every one leaves the same size. WUK supplies two frame sizes, the FX-12S for small parts t
The larger centerless machine in the range, covering 0.5 to 60 mm diameter.
Built for small parts, where high volume and tight size control meet.
Punch pins ground to size without losing the shoulder. Punch grinding is fine work on small diameters, and the machine has to hold the pin without marking it while the wheel takes microns off a shoulder. Our punch grinders clamp from 1 mm right up to 150 mm and swivel the wo
CNC punch and pin grinding from 1 mm up to 150 mm, internal and external.
OD and ID grinding on one machine, for shafts, bushes, needle valves and plungers.
Bring resharpening in house and stop shipping blades out. A dull blade costs more than a sharp one in every way that matters: feed rate, finish, motor load and blade life. WUK builds three resharpeners covering the range most shops actually run, from a 32 kg bench band saw grin
PLC controlled resharpening for circular blades from 80 mm up to 800 mm.
A 130 kg workshop machine that resharpens blades up to 450 mm in minutes.
A 32 kg bench machine that puts band blade sharpening next to the saw.
When the part will not fit a catalogue machine we design the machine. Straight knives from paper converting, plastics recycling, food processing and woodworking are long, thin and impossible to hold on a general purpose grinder. Our linear sharpening machines were built for exactly that ge
Grinds straight knife cutters up to 2000 mm long in a single reference.
The compact linear sharpener, for straight blades up to 700 mm long.
Twelve models across six categories: surface grinding, cylindrical, centerless, punch, saw blade resharpening and customised machines.
Yes. Minimum order is one set, and most customers start that way before adding capacity.
They are taken from our machine data sheets. Where a figure is not documented we mark it as to be confirmed rather than estimating it.
Send us the part drawing, the material and hardness, the batch size and the tolerance that matters. We reply with a model and a wheel specification.
Yes. Custom development from a drawing or a sample part is a normal part of what we do, and several catalogue models started that way.
Send the drawing. We will tell you which machine does the job, and say so if a smaller one will do it just as well.
