Punch pins ground to size without losing the shoulder. Punch grinding is fine work on small diameters, and the machine has to hold the pin without marking it while the wheel takes microns off a shoulder. Our punch grinders clamp from 1 mm right up to 150
Punch grinding is fine work on small diameters, and the machine has to hold the pin without marking it while the wheel takes microns off a shoulder. Our punch grinders clamp from 1 mm right up to 150 mm and swivel the workhead plus or minus 45 degrees so angled forms are ground rather than filed.
CNC punch and pin grinding from 1 mm up to 150 mm, internal and external.
OD and ID grinding on one machine, for shafts, bushes, needle valves and plungers.
Stamping dies stop earning the moment a punch goes undersize or picks up a burr, and sending punches out for regrind puts the press on hold. A punch grinder in the tool room turns that into a same day job, and lets you make replacement punches instead of buying them.
Who buys these machines: Stamping and progressive die shops, press tool makers, connector and terminal manufacturers, and maintenance teams keeping presses running on their own tooling.
The WK22 clamps from 1 mm to 150 mm on both internal and external diameters, which covers pilot pins through to die buttons on the same machine.
Angled lands and tapers are ground by swivelling the head rather than by building a dedicated fixture for every form.
Infinitely variable workhead speed lets small diameters run fast enough to cut cleanly and larger parts run slow enough to stay round.
Long punch blanks pass through the spindle instead of hanging out of the chuck, which is what keeps deflection out of the ground diameter.
Yes. The WK22 internal spindle runs 10000 to 20000 rpm on ER11 collets, which is the speed range small bores need.
Yes. Control brand is your choice from FANUC, SIEMENS, SYNTEC or GSK, and we normally recommend matching what your maintenance team already supports.
1200 x 500 x 1500 mm, at 1280 kg. It fits in a tool room rather than needing a dedicated bay.
Carbide requires a diamond wheel and a rigid setup. Tell us the punch material and geometry and we will confirm the wheel and the workholding before you commit.
15 to 45 working days after deposit for a standard configuration. Special control or fixture requirements are quoted with their own dated schedule.
Send the part drawing or a description of the work and we will tell you which model in this category fits, and what wheel to start with.
