A tool room grinding hardened die plates and bolsters on a manual feed machine, where the operator stands at the handwheel for the whole cycle and part to part consistency follows whoever is on shift.
Plate flatness has to be held across a 600 mm length after heat treatment, on batches where every plate in the set must match. The existing manual machine can reach the tolerance, but only with an experienced operator watching it.
The 3060AHD keeps the familiar 300 x 600 mm table but adds servo vertical feed with automatic down feed from 0.1 to 8 mm and extends X travel to 720 mm so the wheel fully clears a 600 mm plate. Where bolster length is the constraint, the 4080AHD takes a 400 x 800 mm table with 950 mm of travel and three T slots.
One set minimum order, 15 to 45 working days after deposit, EXW FOB CFR or CIF from Shenzhen, with 12 months warranty on the machine.
The grinding cycle becomes a machine setting rather than an operator skill, and plates up to 800 mm are ground against a single reference. Figures quoted on this page are machine specifications, not measured results from a named customer installation.
Servo vertical feed and hydraulic table traverse on a 300 x 600 mm table.
The largest table in the WUK surface grinding range, at 400 x 800 mm with 950 mm of X travel.
A 300 x 600 mm hydraulic surface grinder for small and medium parts in tool rooms and production plants.
If the problem on this page looks like yours, send us the part and the batch size. We will tell you which machine fits and what it will and will not do.
