Skip to content
Since 2006 · China branch of Carl Stahl GmbH Germany [email protected] Tel +86-571-89936190 Ningbo consolidation warehouse
Knowledge Centre

How to use ratchet straps?

how to use ratchet straps ?Please follow the 5 steps to relase your work, and secure the goods.

Carl Stahl lifting equipment
Carl Stahl lifting equipment

How to use ratchet straps?

Ratchet straps are widely used to fastener and secure cargo during transport. When used correctly, these straps can support many different weights and cargo sizes.

  1. Pull the release catch and open the ratchet.(see figure 1&2) The release catch is located in the center of the top movable piece of the ratchet. Pull up the release catch and flip the ratchet fully open.
Carl Stahl lifting equipment

2.Thread the strap through the bottom of the ratchet. (see figure 3) The slot at the bottom of the ratchet, known as the “mandrel,” holds the length of the strap. To thread the strap, start from underneath the ratchet and push it up through the mandrel. The threaded strap should then lay straight, the length of it overlapping with the second strap on the other side of the ratchet.

Carl Stahl lifting equipment

3.Raising and lowering handle.(see figure 4) Pull the handle up and down until the strap tight.

Carl Stahl lifting equipment

4. Pull down the handle of the ratchet when feel tight. (see figure 5)

 The straps fastener the goods, and protect the goods even fall down from the height.

Remember that you can always tighten it with the ratchet later, so don’t worry too much about the length.

Ratchet straps can’t be used to lift goods, please use the ratchet according to the above structions.

Related Articles

More On This Subject

Knowledge

Carl Stahl 5T ratchet tie down

Carl Stahl 5T ratchet tie down is consist of one strong ratchet, webbing, two double J hooks, we supply durable and competitive pr

Related Products

Ratchet Tie Down And Lashing Belt supplied by Carl Stahl China
Ratchet tie down and lashing belt

Ratchet Tie Down And Lashing Belt

Polyester lashing belt with ratchet and hooks in webbing widths from 25 mm to 75 mm, built to European Standard EN 121...

US Type Ratchet Load Binder supplied by Carl Stahl China
Load binder

US Type Ratchet Load Binder

US type ratchet load binder in high quality carbon steel, forged and tempered with 100 percent proof testing, for tens...

Project Cases

Where This Product Has Been Used

Next Step

Questions About This Topic

Send the detail of your application and we will answer it against the standard rather than in general terms.

WhatsApp Email