Moulds For Sanitary Ware Parts
Injection moulds for shower heads, shower bodies, cisterns, seats and cover plates in ABS and PP
All 10 Products In This Category
Moulds For Sanitary Ware Parts
ABS Sanitary Part Mould With S136 Cavity Steel
Stainless quenched cavity for a plated bathroom part
Product materials ABSMould material S136 quenching
Moulds For Sanitary Ware Parts
PP Cover Plate Mould With NAK80 Cavity Steel
Pre-hardened NAK80 on a large flat polypropylene part
Product materials PPMould material DAIDO NAK80
Moulds For Sanitary Ware Parts
ABS Sanitary Part Mould With Three Slides
Three independent pull directions on one impression
Product materials ABSMould material DAIDO S-Star quenching
Moulds For Sanitary Ware Parts
ABS Shower Head Mould With Two Cavities And Six Slides
The most complex tool in the archived catalogue
Product materials ABSMould material DAIDO NAK80
Moulds For Sanitary Ware Parts
PP Cover Plate Family Mould
Two different parts out of the same shot
Product materials PPMould material DAIDO NAK80
Moulds For Sanitary Ware Parts
ABS Sanitary Part Mould With Two Cavities And Four Slides
The highest output sanitary tool in the archive
Product materials ABSMould material S136 quenching
Moulds For Sanitary Ware Parts
ABS Sanitary Part Mould With Submarine Gate
The simplest tool here, and the cheapest to keep running
Product materials ABSCavity 1 x 1
Moulds For Sanitary Ware Parts
ABS Shower Body Mould With S136 Cavity Steel
A heavy section part cooled for what it actually is
Product materials ABSMould material S136 quenching
Moulds For Sanitary Ware Parts
Bush Mould
A small round part moulded on a replaceable core
Moulds For Sanitary Ware Parts
Rotor Mould
Vane geometry cut by EDM rather than milled
What This Category Solves
Plated bathroom parts reject on cavity blemishes that a softer steel cannot avoid over a long production life
Shower geometry pulls in several directions at once, so slide count decides both tool cost and cycle time
Large flat seats and cover plates bow when the cooling is carried over from a smaller tool
Who It Is For And Where It Is Used
Who buys from this category
- Bathroom and sanitary ware brands
- Sanitary component assemblers
- Trading companies holding a bathroom brand
Typical situations
- Moving a European shower tool to an Asian source without changing the part
- Replacing a cover plate tool that has started to bow parts
- Adding a second impression once a launch programme reaches volume
Core Advantages
Stainless cavity steels quenched for plating grade polish retention
Slide counts from one to six, built and proved in our own tool room
Pinpoint, side and submarine gating chosen per part rather than by default
Moulds For Sanitary Ware Parts Questions
What buyers ask before choosing from this category.
How do I choose between the moulds in moulds for sanitary ware parts?
Start with the moulding material and the annual volume. Those two decide the cavity steel and the impression count, which between them are most of the tool price. Everything else follows.
Can a product in this category be built to a different specification?
Yes. Cavity steel, impression count, gate type and mould base standard are all quoted against your part rather than fixed. The specifications shown are what was recorded for that product, not a limit.
Do you supply the moulded parts from these tools as well?
Yes. Injection machines below 600 tons sit on the same site as the tool room, so a tool built here can be run here.
Quote A Moulds For Sanitary Ware Part Project
Send a model, the moulding grade and your annual volume and we will come back with cavity steel, impression count and a measured cycle estimate.