Moulds For Electronic And Audiovisual Parts
Injection moulds for television front shells, enclosures and electronic housings in PC and PC ABS
All 4 Products In This Category
Moulds For Electronic And Audiovisual Parts
ABS Electronic Part Mould With Two Cavities And Six Slides
Six slides across two impressions on a 60 second cycle
Product materials ABSMould material NAK80
Moulds For Electronic And Audiovisual Parts
PC Electronic Part Mould With S136 Cavity Steel
No slides at all, which keeps flash risk near zero
Product materials PCMould material S136
Moulds For Electronic And Audiovisual Parts
PC Electronic Series Mould With SKD61 Cavity Steel
SKD61 with a pinpoint gate for a cosmetic PC part
Product materials PCMould material SKD61
Moulds For Electronic And Audiovisual Parts
Hot Runner Mould With Valve Gate
The only hot runner tool in the archived catalogue
Product materials PC/ABSMould material SKD61
What This Category Solves
A television bezel is a wide thin wall part where one sink mark reads across the whole front face
A long cold runner flow path packs unevenly and bows the frame
Enclosures need six or more slides for vents and connector openings, and each one is a flash line waiting to open
Who It Is For And Where It Is Used
Who buys from this category
- Display and television assemblers
- Electronics brands consolidating enclosure tooling
- IT and communications hardware makers
Typical situations
- A front shell tool whose trial parts must be checked on a flatness fixture
- Consolidating several small enclosure tools with one supplier
- An enclosure where the connector window has to be a replaceable insert
Core Advantages
Valve gated hot runner construction where a cold gate cannot fill evenly
SKD61 and S136 cavities for PC processing temperatures
Slide designs that can be serviced in the press
Moulds For Electronic And Audiovisual Parts Questions
What buyers ask before choosing from this category.
How do I choose between the moulds in moulds for electronic and audiovisual parts?
Start with the moulding material and the annual volume. Those two decide the cavity steel and the impression count, which between them are most of the tool price. Everything else follows.
Can a product in this category be built to a different specification?
Yes. Cavity steel, impression count, gate type and mould base standard are all quoted against your part rather than fixed. The specifications shown are what was recorded for that product, not a limit.
Do you supply the moulded parts from these tools as well?
Yes. Injection machines below 600 tons sit on the same site as the tool room, so a tool built here can be run here.
Quote A Moulds For Electronic And Audiovisual Part Project
Send a model, the moulding grade and your annual volume and we will come back with cavity steel, impression count and a measured cycle estimate.