Moulds For Automotive Interior Parts
Injection moulds for support brackets, door panel parts and tray tables in PC ABS and engineering blends
All 4 Products In This Category
Moulds For Automotive Interior Parts
PC ABS Automotive Part Mould With SKD61 Cavity Steel
SKD61 for the melt temperature and abrasion of PC ABS
Product materials PC/ABSMould material SKD61
Moulds For Automotive Interior Parts
Support Bracket Mould
A load carrying part where the weld line position matters
Moulds For Automotive Interior Parts
Car Door Panel Mould
A large flat tool where cooling decides flatness
Moulds For Automotive Interior Parts
Tray Table Mould
A wide part that has to stay flat under load and heat
What This Category Solves
Interior trim is judged on a fixture, so a tool corrected only against caliper readings still fails at the customer
PC ABS runs hotter than ABS and will flash a tool that was designed around a styrenic
Gate position decides where the weld line lands on a part that carries load
Who It Is For And Where It Is Used
Who buys from this category
- Tier two automotive suppliers
- Interior trim manufacturers
- Programme buyers second sourcing an existing tool
Typical situations
- Adding an interior bracket inside a model year
- Second sourcing a tray table tool and matching the incumbent parts
- Replacing a worn door panel tool without changing the assembly fixture
Core Advantages
SKD61 cavity steel for the melt temperature and abrasion of PC ABS
Submarine gating so interior parts eject without a degating operation
Large flat tools cooled for the panel, not scaled from a small part
Industries This Category Serves
Moulds For Automotive Interior Parts Questions
What buyers ask before choosing from this category.
How do I choose between the moulds in moulds for automotive interior parts?
Start with the moulding material and the annual volume. Those two decide the cavity steel and the impression count, which between them are most of the tool price. Everything else follows.
Can a product in this category be built to a different specification?
Yes. Cavity steel, impression count, gate type and mould base standard are all quoted against your part rather than fixed. The specifications shown are what was recorded for that product, not a limit.
Do you supply the moulded parts from these tools as well?
Yes. Injection machines below 600 tons sit on the same site as the tool room, so a tool built here can be run here.
Quote A Moulds For Automotive Interior Part Project
Send a model, the moulding grade and your annual volume and we will come back with cavity steel, impression count and a measured cycle estimate.