Moulds For Other Product Series
Injection moulds that sit outside the sanitary, automotive, appliance and electronics groups
All 3 Products In This Category
Moulds For Other Product Series
ABS Injection Mould With 718 Cavity Steel
718 pre-hardened steel where stainless is not needed
Product materials ABSMould material 718
Moulds For Other Product Series
ASA Family Mould On LKM Base
A 4+1 family layout matched to a real four to one part ratio
Product materials ASAMould material LKM
Moulds For Other Product Series
Custom Plastic Injection Moulds
Three archived records that carry a name and nothing else
What This Category Solves
A part that does not fit a supplier's usual categories often gets quoted with a safety margin instead of a real number
Family and multi impression layouts are quoted as single cavity tools because nobody asked about the volume
Cheaper mould steels are substituted quietly when the application is not understood
Who It Is For And Where It Is Used
Who buys from this category
- Buyers with a part outside the usual industrial groups
- Programmes needing a family or multi impression layout
- Companies consolidating odd tooling with one source
Typical situations
- A four plus one family tool where four of one part ship with one of another
- A general ABS part that needs a cost effective 718 cavity rather than a stainless one
- A one off tool that still has to be built properly
Core Advantages
Cavity steel quoted against the actual moulding grade, including 718 and LKM base construction
Family layouts where the part ratio genuinely supports them
The same tool room route as the industry specific tools in this catalogue
Moulds For Other Product Series Questions
What buyers ask before choosing from this category.
How do I choose between the moulds in moulds for other product series?
Start with the moulding material and the annual volume. Those two decide the cavity steel and the impression count, which between them are most of the tool price. Everything else follows.
Can a product in this category be built to a different specification?
Yes. Cavity steel, impression count, gate type and mould base standard are all quoted against your part rather than fixed. The specifications shown are what was recorded for that product, not a limit.
Do you supply the moulded parts from these tools as well?
Yes. Injection machines below 600 tons sit on the same site as the tool room, so a tool built here can be run here.
Quote A Moulds For Other Product Serie Project
Send a model, the moulding grade and your annual volume and we will come back with cavity steel, impression count and a measured cycle estimate.