300W Trolley / Pull-Rod Series
Injection Mould Cleaning
Frequent downtime caused by residue, oil and oxidation building up on moulds.
Laser cleaning for Mould & Die Manufacturing
Every hour a tool spends being cleaned is an hour the press is not running.
Why this sector adopts it
A mould is a precision surface with a texture and a cost. Blasting dulls it, solvents leave residue in vents and cavities, and both usually mean pulling the tool. Laser cleaning is non-contact and works in place, which is why our documented mould project cut downtime by 65% and more than doubled tool life.
Related applications
Where it is used
- Injection mould cavity and vent cleaning
- Die-cast tool residue and oxidation removal
- Rubber and tyre mould cleaning
- Cleaning of textured and etched tool surfaces
- Pre-repair cleaning before welding a tool
Documented results in this sector
Machines we would recommend
Trolley / Pull-Rod Series
Trolley Laser Cleaning Machine
100W–300WPulsed fibreAir-cooled
A maintenance bay needs one machine that covers most of the week's work: rust off incoming steel, residue out of a die, paint off a bracket, and occasionally the same job outside in the yard.
Cabinet / Industrial Series
Cabinet Pulse Laser Cleaning Machine
300W–1500WPulsed fibreAir or water cooled
Between a portable cleaner and a full CW industrial system there is a gap: work that needs more than 500W of pulsed energy, all day, on parts where heat input still matters — hardened dies, machined castings, thin structural members, anything that will be measured after cleaning.
Tell us what you make
We will tell you which machine fits your parts, your throughput and your floor — and run a free test on a sample so you can see it before you commit.