Diamond Drawing Dies
Nano Diamond Coated Drawing Dies
Zero wear across the die life, from φ0.50 mm to φ120 mm, for stranding bunching compacting and drawing.
View specifications
PCD Nano Coated and Tungsten Carbide Wire Drawing Dies
Drawing and stranding dies from 0.015 mm to 40.00 mm, chosen by wear rate rather than by price per die.
4 products
The Full Diamond Drawing Dies Range
Diamond Drawing Dies
PCD Wire Drawing Dies
Polycrystalline diamond dies from φ0.03 mm to φ20.00 mm for drawing and to φ40.00 mm for stranding.
View specifications
Diamond Drawing Dies
Polycrystalline Diamond Drawing Dies for Wet and Dry Drawing
PCD dies for any wet or dry drawing process, φ0.03-20.00 mm for wire and φ0.50-40.00 mm for stranding.
View specifications
Diamond Drawing Dies
Tungsten Carbide Wire Drawing Dies
TC dies from 0.015 mm to 32.0 mm, in a large range of nib and hole sizes.
View specificationsThe Problem
What This Category Is For
Die cost is a small line on the budget and a large line on the downtime report. Carbide is economical where tolerance is not critical; PCD runs longer on abrasive wire; nano diamond-coated dies run at least ten times longer than carbide and hold the size while they do it.
Who It Suits
- Wire drawing mills on steel, stainless, copper and aluminium
- Cable stranding, bunching and compacting lines
- Welding wire and saw wire producers
- Tyre cord drawing
- Plants where die change frequency is the bottleneck
Industries
Core Advantages
Why These Machines Are Specified
Three Materials One Supplier
Tungsten carbide 0.015-32.0 mm, PCD 0.03-20.00 mm for drawing and 0.50-40.00 mm for stranding, nano coated 0.50-120 mm.
Longest Life on Abrasive Wire
PCD lasts longer than tungsten carbide, natural diamond and single crystal diamond dies on wet and dry drawing.
Zero Wear Coating
Nano diamond coated dies show effectively no wear across the die life, which holds the wire size constant and saves raw material.
Predictable Surface Finish
Consistent finish along the run rather than drifting as the hole opens up.
Solutions
Where This Category Fits in the Line
Solution
Continuous Drawing Without Breaks
A break is unavoidable. What is avoidable is threading the whole line again.
See the workflowSolution
Die and Tooling Programme
Machines are bought once. Dies are bought every month, and they decide what the machines actually produce.
See the workflowRelated Reading
Guides for This Category
Related Categories
Other Equipment for the Same Plant
Cold Welding Machines
Hand-held and bench machines that join non-ferrous wire by pressure alone, from 0.05 mm hair-fine wire up to 4.50 mm copper.
Hydraulic Pressure Welders
The CHY series covers copper from 1.00 mm to 20.00 mm and aluminium to 25.00 mm, including rectangular strip.
Cold Welding Dies
Industry-standard dies for wire from 0.10 mm to 25.0 mm, single or double cavity, round or profile.
Extrusion Dies and Tips
Compression tooling engineered for concentricity, so the insulation wall can be run thin without breaking through.
FAQ
Diamond Drawing Dies Questions
q
a
q
a
q
a
q
a
Send the Wire Size and the Country
Quotes for diamond drawing dies are built around the wire diameter, the section and the electrical supply where the machine will run.