Non-standard fixtures jigs and made-to-drawing parts · Yiwu China
Yiwu Hongpin Mechanical Equipment Company Request A Quote
ProductsSolutionsMaterialsKnowledgeAboutContact
Product Categories
Precision Turned PartsAluminium Clamping ComponentsSprings and Fasteners
Turned stainless steel shafts bushings and rings laid out on a workbench
Category

Precision Turned Parts

Shafts bushings and rings turned to your drawing, where the working dimension is a diameter and a finish.

Request A Quote
3 Parts In This Group

What Is In This Category

Everything in this group is defined by a diameter that has to be right and a surface that has to be right with it. These are the parts that decide whether a mechanism runs free or binds, and they are the parts most often needed when an original is worn out or no longer available.

Machined aluminium connect ring with a stepped bore and an external retaining groove
Precision Turned Parts

Aluminium Connect Ring

A turned ring that joins two tube or housing sections and holds them concentric while the assembly is fastened.

View The Part
Ground stainless steel precision shaft with a smooth cylindrical running surface
Precision Turned Parts

Precision Shaft

A turned and finished shaft that runs in a bearing or a bushing and holds its diameter along the whole working length.

View The Part
Turned stainless steel precision bushing with a finished bore and chamfered ends
Precision Turned Parts

Precision Bushing

A turned sleeve that carries a shaft, sets the running clearance and takes the wear instead of the housing.

View The Part
Problems Solved

Where Catalogue Parts Run Out

  • The original part is obsoleteA measured sample and a drawing are usually enough to put the machine back into service.
  • Stock sizes do not fitMade-to-drawing turning removes the adaptors and the secondary machining that stock parts force on you.
  • Clearance is a pair, not a partShaft and bushing can be made together so the running clearance is controlled directly.
Who It Suits

Who Buys These

  • Maintenance teams refurbishing machines whose spares have been discontinued
  • Machine builders who need guide shafts and bushes in non-standard sizes
  • Fixture designers specifying guide bushes for a production jig
Specification values on the product pages read Confirmed per project wherever the figure depends on your drawing. That is deliberate: quoting a tolerance before seeing the print would be a guess.
Questions

Questions About Precision Turned Parts

Can you make shaft and bushing as a matched set?
Yes, and where running clearance matters this is the better way to buy them, because the clearance is the difference between two dimensions rather than either one on its own.
What materials do you turn?
Stainless steel, aluminium alloy and engineering plastics, which are the three material families the workshop is set up for.
Can you work from a worn sample?
Usually. The unworn features can be measured directly; the worn running surface has to be interpreted, so tell us what the part runs against and how it failed.
Also Machined Here

Other Categories

Machined aluminium tube clamps and connectors arranged on a light work surface

Aluminium Clamping Components

Clamps and connectors milled and turned to hold round tube exactly where your assembly needs it.

Open
Stainless steel springs wire forms and headed pins on a workshop surface

Springs and Fasteners

Torsion springs wire forms rivets and dowel pins made to drawing when stock ranges do not reach.

Open

Send A Drawing For Precision Turned Parts

Attach the print and say what the part fits against. Tolerances that look tighter than the function needs get raised before you are quoted for them.

Request A Quote By Email Back To All Products

Direct line +86 137 1250 5040  ·  [email protected]