STRONG 90 Micromotor
A dental laboratory micromotor: a control box, foot or knee control and handpiece used for grinding, trimming and finishing at the bench. This version is for Strong systems. One controlled speed source for the whole finishing sequence, from gross trimming down to polishing.
Specification
| Catalogue Reference | S20 |
|---|---|
| Series | Strong |
| Max. Speed | 35,000 rpm |
| Voltage | 220V or 110V |
Every value above is reproduced from the You Dent catalogue for this item. Anything not listed is confirmed in writing on the quotation rather than estimated here.
Key Benefits
- One controlled speed source for the whole finishing sequence, from gross trimming down to polishing.
- Brushless and brush models in the same catalogue, so a lab can standardise on one control system.
- Brushless and brush micromotors, 35K and 45K handpieces, and the carbon brushes, armatures, chucks and bearings that keep them turning.
Problems It Solves
- Bench work that stalls when a single motor fails
- Speed that drops under load part-way through a cut
- Control boxes that cannot be serviced locally
Who It Is For
- Crown and bridge laboratories
- Denture and orthodontic laboratories
- Clinics with an in-house lab
- Equipment dealers
How It Compares
Bench micromotors of this type are the general-purpose alternative to a dedicated high-speed grinder, which is faster but far less versatile.
Use Guide
Match the speed to the instrument, not to the job: separating discs and finishing points have maximum rated speeds that should not be exceeded.
Configurations
The catalogue lists this item under more than one reference, one per configuration. Quote the reference you need and we will confirm it back to you.
| Reference | Configuration |
|---|---|
| S20 | STRONG 90 Control box +On/Off Pedal+Handpiece Holder |
| S2011 | YouDent 102L Handpiece |
| S2013 | YouDent SDE-M33Es E-type |
| S2014 | YouDent SDE-M33Es E-type +Straight Connector |
| S2015 | YouDent SDE-M33Es E-type +Contra Angle |
| S2016 | YouDent SDE-M33Es E-type+Straight Connector+Contra Angle |
| S2001 | STRONG 102L Handpiece |
| S20 | 02 |
From the Catalogue Listing
- 2.9Ncm
- Compact size
- +STRONG 102 Handpiece
Where It Is Used
Trimming and shaping cast frameworks
Finishing acrylic denture bases
Adjusting zirconia copings after sintering
Plaster and model work at the bench
More From Dental Lab Micromotors
Questions About STRONG 90 Micromotor
Is the foot control included?
It depends on the configuration. The original specification for each model is reproduced on this page where the old catalogue stated it; confirm the exact set contents on your quotation.
What voltage is supplied?
Several models are 220V only and others are available in 220V or 110V. Tell us your country when you enquire and we will confirm in writing.
How do I get a price for STRONG 90 Micromotor?
Send us the quantity and your destination country on WhatsApp or by email and we will quote STRONG 90 Micromotor delivered. It can be consolidated into one shipment with anything else you are ordering from the Dental Lab Micromotors range.
Get a Price on STRONG 90 Micromotor
Send the quantity and your destination country. We will confirm specification, voltage where it applies, and the delivered price in writing.