Concrete Cover Grating
Hook-type steel covers that sit in a concrete kerb or pit and lift out for cleaning.
Every Concrete Cover Grating We Publish
A concrete cover panel is a grating panel built as a lid: it has to carry the traffic that crosses it, drop cleanly into a cast frame or kerb, stay put under load and still lift out when the chamber underneath needs clearing. The hook, the frame and the edge detail are as much of the product as the mesh. ShengJingYe builds these from 30x2.5 bearing bar for light pedestrian covers up to 100x5 for panels that take vehicles.
Concrete Cover Grating 30x2.5 Hook Type
Light-duty hook cover panel on 30x2.5 bearing bar with 8x2 cross bar, hot-dip galvanized, for chambers crossed by pedestrians and hand trolleys.
See the specification
Concrete Cover Grating 65x5 Heavy Duty
Heavy cover panel on 65x5 bearing bar with a 6 mm round cross bar, hot-dip galvanized, for chambers crossed by forklifts and light vehicles.
See the specification
Concrete Cover Grating 100x5 With Flat Cross Bar
The heaviest published cover section: 100x5 bearing bar with a 30x5 flat cross bar, hot-dip galvanized, for wide openings and vehicle loads.
See the specification
Concrete Cover Grating 100x5 Vehicle Duty Panel
100x5 bearing bar with 30x5 flat cross bar, built and banded as a stacked panel set for repeated openings along one trench run.
See the specificationProblems This Family Solves
- Covers that rock in the frame and bang every time a wheel crosses them
- Panels that cannot be lifted by one person when the chamber needs clearing
- Hooks and edge bars that rust out years before the mesh does
- Covers ordered to a nominal opening that do not fit the opening as actually cast
- Panels that deflect visibly under a wheel load because the bearing bar was specified by price
Who It Is For
- Civil contractors covering drainage chambers, sumps and cable pits
- Municipal and highway maintenance departments replacing broken covers
- Industrial plants with trenches crossing vehicle routes
- Precast and civil product manufacturers who need the steel top for their chamber
How This Family Actually Looks
Photographs taken by the factory of products in this family, lit and in production. Nothing here is a rendering of something that does not exist.
Why Buyers Choose This Range
- Bearing bar from 30x2.5 to 100x5 so the panel is specified to the wheel load, not to a default
- Hooks, lifting points and banding fabricated with the panel
- Hot-dip galvanized after fabrication, so the cut ends and welds are coated too
- Built to the opening as it exists on site rather than to the nominal dimension
- Heavy sections available in the same run as the light ones
Typical Application Scenarios
- Drainage and inspection chambers in yards and access roads
- Cable and service pits inside plants and substations
- Trench covers crossing forklift and truck routes
- Kerbside gully and sump covers in municipal works
Where This Family Has Been Photographed
Concrete Cover Grating Questions
How do I specify the load?
Can the covers be hinged or locked down?
What size panels can be lifted by hand?
Do you galvanize before or after fabrication?
Can you match an existing cover?
Get The Concrete Cover Grating Specifications
Tell us which products you are shortlisting and the specifications come back by email, with packing and a schedule for your quantity.