Custom and OEM Nozzle Manufacturing
Standard and non standard nozzles made to your drawing or to a sample, including OEM marking and small volume batches.
The Situation
Why Buyers Come to Us With This
Machine builders and distributors often need a nozzle that no catalogue carries: an unusual thread, a special body length, a marking of their own, or a discontinued part that a customer still runs. Minimum order quantities elsewhere make that uneconomic.
Step by Step
How the Work Runs
Drawing or Sample
No drawing exists for most obsolete parts.
We work from a drawing when you have one and from a physical sample or photographs when you do not.
Material and Finish
The original material is not always the right one to repeat.
Brass and 303, 304 and 316 stainless steel are the standard stock; we advise where a change would extend service life.
First Article
A full batch made to a misread dimension is scrap.
Samples can be ready within 10 days so the first article is checked on your equipment.
OEM Marking
Distributors need the part to carry their identity.
OEM orders are accepted, including customer marking on the body.
Repeat Supply
Small annual volumes get pushed to the back of a queue elsewhere.
Small volume orders are accepted, so a low usage part stays available.
What You Get
Deliverables
- Non standard nozzles machined to drawing or to a supplied sample
- Customer marking under an OEM order
- First article samples within 10 days
- Small volume batches for low usage parts
Products
Typical Parts Supplied This Way
Air Atomizing Nozzle
View specification
Ceramic Trim Cutting Spray Nozzle
View specification
Double Trim Cutting Nozzle
View specification
Single Orifice Ruby Trim Cutter Nozzle
View specification
Paper Making Trim Cutting Nozzle
View specification
Disc Filter Washing Nozzle
View specification
Disc Shower Spray Nozzle
View specification
Disc Shower Nozzle
View specification
Related Guides
Useful Background
Other Routes
Other Ways We Work
Questions Buyers Ask
Custom and OEM Nozzle Manufacturing Questions
How long does custom and oem nozzle manufacturing normally take?
The engineering answer usually comes back within 6 hours because that is the stated inquiry response. Where a sample is needed, samples can be ready within 10 days.
Do I need a drawing to start?
No. Photographs of the existing part against a rule, the thread standard and a description of the duty are enough to begin. A drawing shortens the process where you have one.
What is the smallest order you will take on this route?
Small volume orders are accepted. A single position on a header is a normal first order, and trial samples can be sent free of charge.
What guarantee comes with the parts?
The product listings state a 3 month quality guarantee, and every product is tested before it is packed.
Start Custom and OEM Nozzle Manufacturing With One Email
Describe the duty and attach photographs of the existing part. Inquiries are answered within 6 hours.