Carbide Rods
Solid Carbide Rods
Sintered and ground solid carbide rod blanks for rotary tool manufacturing and wear pins
Product Detail
Product Category
Tungsten Carbide Rods and Blanks
Sintered tungsten carbide rod blanks for drills end mills reamers and wear pins supplied solid with two helical coolant holes chamfered or fully customised to your drawing.
Problems It Solves
What Goes Wrong Today
- Tool bodies made from high speed steel lose their edge long before the shift ends
- Deep hole drilling stalls because coolant never reaches the cutting zone
- Rod stock arrives out of straightness so the grinder loses time on setup
Benefits
What Changes With Carbide
- One rod family covers drills end mills reamers and wear pins so stock is simpler
- Helical coolant holes are formed during extrusion rather than drilled afterwards
- Sinter-HIP densification reduces residual porosity that would show up as edge chipping
Types We Produce
Forms in This Category
- Tungsten carbide solid rods
- Carbide two helix rods
- Custom made carbide rods
- Carbide rods with chamfer
- Sintered carbide rods
Grades tolerances and dimensions are confirmed against your drawing when you enquire.
Product Photographs
Carbide Rods in Production
These are photographs of parts produced in our own plant. Each caption describes what the picture actually shows.
Application Scenarios
Industries That Use This Category
Keep Reading
Related Cases and Guides
Carbide Sleeve With 176 Holes
A carbide sleeve of OD 268 mm x ID 228.6 mm x H 160 mm carrying 176 holes produced for oil field service equip…
Read MoreTungsten Carbide Grade Guide
How cobalt content and grain size move hardness against toughness and how to describe your application so a su…
Read MoreSinter-HIP Process Guide
The production route from WC powder through ball milling spray drying pressing Sinter-HIP and machining and wh…
Read More
FAQ
Carbide Rods FAQ
Which industries buy carbide rods from you?
Mainly Wood and Metal Cutting, Automotive and Bearing, Metal Forming and Wire Drawing. Tell us your application and we will confirm what suits it.
Can you produce carbide rods to our drawing?
Yes. Custom made carbide parts to drawing are a normal part of our production. Send the drawing or a measured sample and we will confirm what is manufacturable in carbide.
What material are these parts made from?
Cemented tungsten carbide which is tungsten carbide grain in a cobalt binder. The grade direction is chosen with our engineers against your load case rather than sold as one universal grade.
How are the parts densified?
Blanks are densified by Sinter-HIP which applies isostatic gas pressure during the sintering cycle so residual porosity is reduced before machining.
What do you need in order to quote?
The drawing or a sketch with measured dimensions the quantity and a short description of the application. Send it on WhatsApp to +86 187 7492 5813 or by email to [email protected].
Next Step
Get a Quotation for Carbide Rods
Send the drawing the quantity and a short note about the application. Our engineers reply with a specification you can check before ordering.
Send a drawing or a sample photo on WhatsApp or by email. Files are reviewed by our production engineers, not by a form.