Carbide Tubes
Carbide Tubes and Bushes
Ground bore and outside diameter for pump sleeves guide bushes and flow parts
Product Detail
Product Category
Tungsten Carbide Tubes and Bushes
Tungsten carbide tubes and bushes for pump sleeves guide bushes nozzle bodies and downhole flow components where an internal bore has to keep its size in abrasive service.
Problems It Solves
What Goes Wrong Today
- Bores open up under abrasive flow and clearances go out of specification
- Steel bushes gall against hardened shafts and seize
- Thin wall carbide parts crack when they are ground without support
Benefits
What Changes With Carbide
- Bore and outside diameter ground on the same setup for concentricity
- Wall thickness and length agreed at drawing stage to keep the part manufacturable
- Same material route as our sleeve and ring production
Types We Produce
Forms in This Category
- Carbide tube blanks
- Ground carbide bushes
- Carbide drilling bushes
Grades tolerances and dimensions are confirmed against your drawing when you enquire.
Product Photographs
Carbide Tubes in Production
These are photographs of parts produced in our own plant. Each caption describes what the picture actually shows.
Related
All Product Categories
Products in This Category
Application Scenarios
Industries That Use This Category
Keep Reading
Related Cases and Guides
Carbide Sleeve With 176 Holes
A carbide sleeve of OD 268 mm x ID 228.6 mm x H 160 mm carrying 176 holes produced for oil field service equip…
Read MoreAPI V11 Valve Pair Supply
Tungsten carbide ball and seat valve pairs in the API V11 series produced for subsurface oil well pumps togeth…
Read MoreTungsten Carbide Grade Guide
How cobalt content and grain size move hardness against toughness and how to describe your application so a su…
Read MoreSinter-HIP Process Guide
The production route from WC powder through ball milling spray drying pressing Sinter-HIP and machining and wh…
Read More
FAQ
Carbide Tubes FAQ
Which industries buy carbide tubes from you?
Mainly Petroleum and Gas, Metal Forming and Wire Drawing. Tell us your application and we will confirm what suits it.
Can you produce carbide tubes to our drawing?
Yes. Custom made carbide parts to drawing are a normal part of our production. Send the drawing or a measured sample and we will confirm what is manufacturable in carbide.
What material are these parts made from?
Cemented tungsten carbide which is tungsten carbide grain in a cobalt binder. The grade direction is chosen with our engineers against your load case rather than sold as one universal grade.
How are the parts densified?
Blanks are densified by Sinter-HIP which applies isostatic gas pressure during the sintering cycle so residual porosity is reduced before machining.
What do you need in order to quote?
The drawing or a sketch with measured dimensions the quantity and a short description of the application. Send it on WhatsApp to +86 187 7492 5813 or by email to [email protected].
Next Step
Get a Quotation for Carbide Tubes
Send the drawing the quantity and a short note about the application. Our engineers reply with a specification you can check before ordering.
Send a drawing or a sample photo on WhatsApp or by email. Files are reviewed by our production engineers, not by a form.