Carbide Gear
Carbide Gears
Profile ground and EDM finished carbide gears for abrasive drive positions
Product Detail
Product Category
Tungsten Carbide Gears and Toothed Parts
Tungsten carbide gears and toothed wear components produced from pressed blanks and finished by profile grinding and EDM for drive positions that destroy hardened steel.
Problems It Solves
What Goes Wrong Today
- Steel gears in abrasive or corrosive drives wear out of profile quickly
- Tooth wear shows up as backlash and positioning error in the machine
- Special toothed wear parts are rarely available off the shelf
Benefits
What Changes With Carbide
- Tooth profile holds its geometry far longer than hardened steel in abrasive duty
- Parts are produced from your drawing including module and tooth count
- Blank pressing grinding and EDM finishing handled in one plant
Types We Produce
Forms in This Category
- Carbide gears
- Toothed carbide rings and hubs
Grades tolerances and dimensions are confirmed against your drawing when you enquire.
Product Photographs
Carbide Gear in Production
These are photographs of parts produced in our own plant. Each caption describes what the picture actually shows.
Related
All Product Categories
Products in This Category
Application Scenarios
Industries That Use This Category
Keep Reading
Related Cases and Guides
Carbide Sleeve With 176 Holes
A carbide sleeve of OD 268 mm x ID 228.6 mm x H 160 mm carrying 176 holes produced for oil field service equip…
Read MoreTungsten Carbide Grade Guide
How cobalt content and grain size move hardness against toughness and how to describe your application so a su…
Read MoreSinter-HIP Process Guide
The production route from WC powder through ball milling spray drying pressing Sinter-HIP and machining and wh…
Read More
FAQ
Carbide Gear FAQ
Which industries buy carbide gear from you?
Mainly Metal Forming and Wire Drawing, Automotive and Bearing. Tell us your application and we will confirm what suits it.
Can you produce carbide gear to our drawing?
Yes. Custom made carbide parts to drawing are a normal part of our production. Send the drawing or a measured sample and we will confirm what is manufacturable in carbide.
What material are these parts made from?
Cemented tungsten carbide which is tungsten carbide grain in a cobalt binder. The grade direction is chosen with our engineers against your load case rather than sold as one universal grade.
How are the parts densified?
Blanks are densified by Sinter-HIP which applies isostatic gas pressure during the sintering cycle so residual porosity is reduced before machining.
What do you need in order to quote?
The drawing or a sketch with measured dimensions the quantity and a short description of the application. Send it on WhatsApp to +86 187 7492 5813 or by email to [email protected].
Next Step
Get a Quotation for Carbide Gear
Send the drawing the quantity and a short note about the application. Our engineers reply with a specification you can check before ordering.
Send a drawing or a sample photo on WhatsApp or by email. Files are reviewed by our production engineers, not by a form.