Carbide Dies
Carbide Forging Dies
Sinter-HIP densified dies for engine valve heading and hot forming
Product Detail
Product Category
Tungsten Carbide Dies for Forging and Cold Forming
Tungsten carbide dies forging dies and cold forming dies produced with Sinter-HIP densification for good lifespan under repeated impact and high contact pressure.
Problems It Solves
What Goes Wrong Today
- Die cavities wear open and the formed part drifts out of tolerance
- Micro cracks start at porosity left after conventional sintering
- Every die change costs a press setup and a batch of scrap parts
Benefits
What Changes With Carbide
- Sinter-HIP closes residual porosity that would act as a crack starter
- Longer runs between die changes on fastener and valve forming lines
- Blanks or finished dies can be supplied depending on your own tool room
Types We Produce
Forms in This Category
- Hot forging dies
- Cold forming and extrusion dies
- Die blanks and die inserts
Grades tolerances and dimensions are confirmed against your drawing when you enquire.
Product Photographs
Carbide Dies in Production
These are photographs of parts produced in our own plant. Each caption describes what the picture actually shows.
Application Scenarios
Industries That Use This Category
Keep Reading
Related Cases and Guides
Carbide Sleeve With 176 Holes
A carbide sleeve of OD 268 mm x ID 228.6 mm x H 160 mm carrying 176 holes produced for oil field service equip…
Read MoreTungsten Carbide Grade Guide
How cobalt content and grain size move hardness against toughness and how to describe your application so a su…
Read MoreSinter-HIP Process Guide
The production route from WC powder through ball milling spray drying pressing Sinter-HIP and machining and wh…
Read More
FAQ
Carbide Dies FAQ
Which industries buy carbide dies from you?
Mainly Metal Forming and Wire Drawing, Automotive and Bearing. Tell us your application and we will confirm what suits it.
Can you produce carbide dies to our drawing?
Yes. Custom made carbide parts to drawing are a normal part of our production. Send the drawing or a measured sample and we will confirm what is manufacturable in carbide.
What material are these parts made from?
Cemented tungsten carbide which is tungsten carbide grain in a cobalt binder. The grade direction is chosen with our engineers against your load case rather than sold as one universal grade.
How are the parts densified?
Blanks are densified by Sinter-HIP which applies isostatic gas pressure during the sintering cycle so residual porosity is reduced before machining.
What do you need in order to quote?
The drawing or a sketch with measured dimensions the quantity and a short description of the application. Send it on WhatsApp to +86 187 7492 5813 or by email to [email protected].
Next Step
Get a Quotation for Carbide Dies
Send the drawing the quantity and a short note about the application. Our engineers reply with a specification you can check before ordering.
Send a drawing or a sample photo on WhatsApp or by email. Files are reviewed by our production engineers, not by a form.