Carbide Pins
Carbide Pins and Studs
Wear resistant pins for tyre skid studs horseshoe grips and machine wear seats
Product Detail
Product Category
Tungsten Carbide Pins and Horseshoe Pins
Tungsten carbide pins and horseshoe pins with very good wear resistance for tyre skid studs horseshoe grips bearing seats and general wear locations.
Problems It Solves
What Goes Wrong Today
- Steel studs wear flat within a season and grip is lost on ice and hard ground
- Soft pins deform in the seat and become difficult to replace
- Small parts are hard to buy in consistent quality at production volume
Benefits
What Changes With Carbide
- Very good wear resistance keeps the working tip sharp for longer service
- Batch production keeps diameter and length consistent across thousands of pieces
- Shapes can be adjusted to the holder you already use
Types We Produce
Forms in This Category
- Carbide pins for tyre skid studs
- Horseshoe pins
- Wear pins and locating pins
Grades tolerances and dimensions are confirmed against your drawing when you enquire.
Product Photographs
Carbide Pins in Production
These are photographs of parts produced in our own plant. Each caption describes what the picture actually shows.
Related
All Product Categories
Products in This Category
Application Scenarios
Industries That Use This Category
Keep Reading
Related Cases and Guides
Carbide Sleeve With 176 Holes
A carbide sleeve of OD 268 mm x ID 228.6 mm x H 160 mm carrying 176 holes produced for oil field service equip…
Read MoreTungsten Carbide Grade Guide
How cobalt content and grain size move hardness against toughness and how to describe your application so a su…
Read MoreSinter-HIP Process Guide
The production route from WC powder through ball milling spray drying pressing Sinter-HIP and machining and wh…
Read More
FAQ
Carbide Pins FAQ
Which industries buy carbide pins from you?
Mainly Automotive and Bearing, Mining and Drilling. Tell us your application and we will confirm what suits it.
Can you produce carbide pins to our drawing?
Yes. Custom made carbide parts to drawing are a normal part of our production. Send the drawing or a measured sample and we will confirm what is manufacturable in carbide.
What material are these parts made from?
Cemented tungsten carbide which is tungsten carbide grain in a cobalt binder. The grade direction is chosen with our engineers against your load case rather than sold as one universal grade.
How are the parts densified?
Blanks are densified by Sinter-HIP which applies isostatic gas pressure during the sintering cycle so residual porosity is reduced before machining.
What do you need in order to quote?
The drawing or a sketch with measured dimensions the quantity and a short description of the application. Send it on WhatsApp to +86 187 7492 5813 or by email to [email protected].
Next Step
Get a Quotation for Carbide Pins
Send the drawing the quantity and a short note about the application. Our engineers reply with a specification you can check before ordering.
Send a drawing or a sample photo on WhatsApp or by email. Files are reviewed by our production engineers, not by a form.