Two Post Lift
ATL40B Two Side Manual Lock Base Floor Two Post Lift
4T base floor two post lift with bilateral manual lock
Bay Solutions
General Repair Bay
One lift that suits the building you have, plus the oil handling equipment that keeps the floor safe.
How the Bay Gets Specified
- Check the headroomIf an overhead beam will not fit, a base floor two post lift moves the connection to the floor.
- Check the floorA protected or thin slab points to a mobile mid-rise lift or a trench-free model with a 110 mm start height.
- Pick the lock typeElectric lock release keeps the procedure identical between technicians; manual locks cost less.
- Handle the waste oilAir-powered drainers and extractors need no bay power and leave no spark risk.
- Install and inspectWe supply the anchor pattern and slab specification before delivery.
Equipment in This Solution
Every machine below is in the published range, with its own specification page.
Scissor Lift
ASL27M 2.7T Middle Rise Scissor Lift
Trench-free mid-rise lift with 110 mm start height
Waste Oil Extractor & Drainer
Waste Oil Extractor & Drainer 3197H
90L combined extractor and drainer
From Enquiry to Handover
What We Handle at Each Stage
Survey
Bay dimensions, ceiling height, slab condition and vehicle mix.
Specify
Machines matched to the constraints, with the trade-offs stated.
Drawings
Anchor pattern, slab specification and pit drawing before civil work.
Build
Built to your local voltage and frequency, then crated for container loading.
Commission
Technical support through installation, calibration and first use.
Related Guides
Two Post or Scissor Lift for a General Repair Bay
The choice is usually decided by the building rather than the vehicles. Here is how ceiling height, slab condition and the work you take in point to one or the other.
Clear Floor or Base Floor Two Post Lift
Both carry the same 4 tonnes. The difference is where the connection between the columns runs, and that decides which building each one suits.
What to Check Before a Workshop Lift Is Delivered
Most installation problems are decided weeks before the crate arrives. These are the checks that stop a lift turning up for a bay that cannot take it.
Frequently Asked Questions
Can you quote the whole bay in one go?
Yes, and it is usually cheaper. Machines shipped together share the container space, which lowers the freight cost per unit.
What information do you need to specify the bay?
Bay dimensions, ceiling height, slab condition, whether the floor can be cut, your vehicle mix and your local voltage.
Do you supply the drawings before the civil work starts?
Yes. For in-ground equipment we send the foundation drawing before the pit is cut, so the pocket is right the first time.
Who installs the equipment?
Installation is carried out locally by a competent installer. We supply the drawings, the manual and technical support during commissioning.
Can we phase the purchase?
Yes. Several machines are supplied with upgrade paths, such as reserved mounting holes for an assistant arm on the ATC830 and ATC850.
Specify a General Repair Bay
Send the bay dimensions, the ceiling height and what you take in. We will come back with the equipment list, the price and the drawings.