Stainless Steel Bar
Round square flat and hexagonal bar in 301 316 316L 317 410 and 904L, hot rolled or cold drawn, black peeled bright or polished, 0.3 m to 12 m.
Every Product in This Category
Bar is bought for what comes off the lathe, so profile, surface condition and length matter as much as grade. This category covers the austenitic grades for corrosion duty, 301 where strength is built by cold working, 410 where the part must be hardened, and 904L where the medium is a reducing acid.
317 Stainless Steel Bar
SUS317 and 317L is a molybdenum bearing stainless steel whose molybdenum content sits slightly above that of 316. Bar is produced…
View specifications →
316L Stainless Steel Bar
316L is widely used in the chemical industry for its corrosion resistance. It is a derivative of 18-8 austenitic stainless steel…
View specifications →
316 Stainless Steel Bar
316 stainless steel bar carries high nickel and chromium, which gives it oxidation resistance, corrosion resistance, acid and…
View specifications →
301 Stainless Steel Bar
Type 301 is a chromium nickel austenitic stainless steel that reaches high strength and ductility by cold working rather than by…
View specifications →
410 Stainless Steel Bar
Grade 410 is the basic martensitic stainless steel, written as 1.4006 or X12Cr13 under EN and UNS S41000 under the UNS system. AISI…
View specifications →
201 Stainless Steel Pipe
201 stainless steel pipe is produced as decorative pipe, industrial pipe, boiler pipe to A249 TP201, seamless pipe and A213 TP201…
View specifications →Problems This Category Solves
- Excess machining stock when black bar is bought instead of peeled or bright
- Offcut waste from fixed 6 m lengths on short component runs
- Shaft and fastener failure when the grade does not match the medium
- Austenitic grades that cannot be hardened for wear duty
Who Buys It
- Machine shops turning corrosion resistant components
- Pump and valve manufacturers sourcing shafting and trim
- Fastener makers working from hexagonal stock
- Distributors stocking bar across profiles and grades
What the Works Can Actually Produce
- Round bar from 3 mm up to 1200 mm depending on grade
- Square, flat and hexagonal profiles in the same grades
- Length 0.3 m to 12 m or cut to your list
- Black, peeled, bright and polished surface conditions
- MTC, CE, ISO and PED documentation on the 316L programme
Typical Applications
- Pump shafts and valve stems in acid and seawater service
- Fastener and stud blanks turned from hexagonal bar
- Structural angle inside chemical and water treatment plant
- Hardened wear components machined from 410
Where This Material Ends Up
Chemical Processing
Chemical plants are where material selection stops being a cost decision. Sulphuric, phosphoric, acetic,...
Marine and Shipbuilding
Seawater is a stagnant chloride solution with biology in it, and that combination takes apart alloys that...
Water and Fire Protection
Water systems are long life assets where the pipe is buried, embedded or hidden in a riser, so replacement...
Oil Gas and Petrochemical
Petrochemical service mixes acid, alkali and salt in one plant, and the line that is fine on Monday can be...
Stainless Steel Bar Questions Buyers Ask
What is the largest round bar diameter available
Which surface condition should I order
Can you cut bar to our length
What is the minimum order on 316L bar
Which bar grade can be hardened by heat treatment
Do you provide third party inspection on bar
Get a Quotation for Stainless Steel Bar
Send the grade, the size, the wall or thickness, the quantity and the destination port. A quotation with lead time and certificate level comes back the same working day where possible.