Spring and Gear Manufacturing
Compressive stress on springs, gears and bearing races, where fatigue life is the deliverable.
Pain Points On This Line
- Cast shot with internal pores breaks early and drops the peening intensity mid-cycle
- Mixed grain sizes give an uneven stress profile across the batch
What Buyers Ask For
- Cut wire with length equal to diameter for uniform density
- Spring wire grades at 45-55 HRC and 55-65 HRC
- Conditioned round grain for peening
Recommended Products
Carbon steel
Carbon Steel Cut Wire Shot Conditioned
New steel wire and spring wire, 0.2 mm to 2.5 mm, rounded
Carbon steel
Carbon Steel Cut Wire Shot As Cut
New steel wire and spring wire, 0.2 mm to 2.5 mm
Steel balls
Low Carbon Steel Balls
AISI 1015 / 1010 / Q235, G10 to G1000, 0.5 mm to 30 mm, 55-62 HRCHow An Enquiry Runs
From the first message to the pallet leaving Yongkang.
Frequently Asked Questions
Which media do you recommend for spring and gear manufacturing
The products listed on this page cover the substrates and processes named above. Send the part material, the current media and the finish you need and we will confirm the alloy, shape and grain size.
What volumes do you supply
Supply ability is 500,000 kg per month across most ranges and 1,000,000 kg on the stainless steel shot lines. Minimum order is 500 kg on most ranges and 1,000 kg on carbon steel cut wire shot.
Do you deliver to our country
Products are exported to more than 50 countries including Germany, Japan, the United States, Singapore, Malaysia, Thailand, Vietnam, South Korea, Colombia, Argentina and Indonesia. Send your destination port for a quote.
Can we trial the media before switching over
Yes. The minimum order is set low so a trial batch can be run on your own parts before a volume commitment.
Talk To Us About Spring and Gear Manufacturing
Send the part material, the current media and the finish you have to hand over.
Minimum order from 500 kg. Packed 25 kg per bag, 40 bags per pallet. Quotes in USD, terms T/T.