Oil Gas and Chemical Plants
Attach alcohol screening to the identity record at a permit controlled entrance, with terminals holding 10000 faces and 20000 test records.
What Makes This Setting Different
A wall mounted alcohol screening terminal is the right tool when a person arrives at a controlled access point and the decision to allow entry must be made quickly and recorded. The ALC-605, ALC-607 and ALC-608 terminals use fuel cell sensors to detect breath alcohol, measure body temperature, and recognise faces. They are designed to integrate with existing permit to work systems by linking the screening result to the same identity record used for access control.
Pain points we hear
- Screening results are recorded in a separate notebook, making it hard to link a test to a specific person or shift
- Contractors and visitors outnumber staff, increasing the risk of unverified entry after screening
- A terminal that does not store a record of who was tested and when cannot support an incident investigation
- A system that cannot verify identity may allow someone else to take a test on behalf of the person entering
- A slow or unresponsive terminal causes delays at high-traffic access points
What Buyers Need
- A terminal that stores 10000 registered faces and 20000 test records for audit and investigation
- Hardware that responds in 5 seconds and works reliably in a 10 C to 50 C operating range
- A system that links the screening result to the same identity record used for access control
- A device that can detect if a person is wearing a mask, preventing bypass of the test
- A terminal that runs on 12V DC or 100V-240V AC to suit different site power systems
Typical Scenarios
- Permit to work gate at an oil and gas platform where contractors must be screened before entry
- Chemical plant turnaround with a contractor crew arriving on one shift
- Entry checkpoint at a refinery where visitors must be verified and tested before access
- Controlled access point during a safety audit where all personnel must be logged
- Remote site with no on-site staff, where screening must be automated and self-verified
How the Programme Runs
Integrate with access control
Problem A screening result that is not linked to a person’s identity record cannot be used to verify compliance
How we solve it The terminal stores face data and test records together, so the result is tied to the individual at the time of entry
Configure alarm threshold
Problem A fixed alarm point does not match the legal or policy limit in every site or country
How we solve it The alarm point is set at the service centre to 0.02%, 0.05%, or 0.08% before shipment, based on the destination site’s policy
Deploy at access point
Problem A terminal that fails in high humidity or temperature extremes cannot be trusted during a shift
How we solve it The terminal operates in 10 C to 50 C and withstands up to 95% humidity, suitable for outdoor and industrial environments
What You Get When You Order
- Units are configured for the destination site’s alarm threshold before shipment
- Face and test data are preloaded based on the site’s access list, if provided
- Calibration and recalibration intervals are confirmed in writing at order time
Models That Fit This Setting
Breath Alcohol Tester with Body Temperature ALC-605
The ALC-605 is a wall mounted alcohol screening terminal with integrated fuel cell breath alcohol detection, facial re...
View specification →
Alcohol Screening Terminal ALC-607
The ALC-607 is the pole and wall mounted member of the ALCOKSON alcohol screening terminal range, alongside the ALC-60...
View specification →
Breath Alcohol Tester with Body Temperature ALC-608
The ALC-608 is a wall mounted alcohol screening terminal that combines breath alcohol testing, facial recognition, bod...
View specification →
Questions Buyers Ask Before Ordering
Which terminal should I use for a high-traffic site with contractors?
How many faces and test records can the terminal store?
Can the alarm point be changed after delivery?
What power supply does the terminal need?
Is the ALC-607 different from the ALC-605 or ALC-608?
What is the lead time and minimum order?
Put a screening programme in place for oil gas and chemical plants
Send the number of gates or vehicles, the shift pattern and the market you operate in. We will name the models and the configuration and put the figures in writing.