Installed audio runs are long, concealed and permanent. Getting the conductor size wrong costs level at the far end, and nobody is re-pulling a ceiling ring to fix it.
Cable resistance in series with the speaker costs level and damping factor. Longer runs and lower impedance loads need more copper.
Flat figure-8 for under carpet gripper and behind trim. Round for conduit and ceiling void pulls where it has to slide.
4-conductor halves the number of pulls for bi-wire runs and stereo pairs fed from one amplifier position.
Red/black, striped and transparent jackets all give an unambiguous identification in a dark ceiling.
Concealed wall runs normally require a jacket rated for the application — use the in-wall specification rather than general-purpose cable.

The profile that pulls cleanly through conduit and ceiling voids.
Explore the range →
The profile that hides under carpet grippers and skirting.
Explore the range →
in wall speaker wire electrical signal cable unshielded pvc jacket power audio alarm…
View specification →
Low Voltage LED Cable 2 Conductor In-Wall In Ground PVC Jacketed CCA CU Speaker Wire…
View specification →
4 Conductor In Wall Speaker Wire Audio Cable For Security,Alarm,Electrical,Signal, Low…
View specification →
4 Conductor Speaker Cable Low Voltage LED Signal Audio Wire Copper Clad Aluminum for in Wall…
View specification →
Black Red 2 Pin Speaker Wire Cable Connection Wire Twin Cord Flat For Single LED Strip Lighting
View specification →
2 Pin Transparent Loudspeaker Twin Flat Cable HiFi Car Stereo Speaker Wire 24 Strand 0.75mm2…
View specification →Send the speaker impedance and the total run and we will confirm which stocked cross-section keeps the loss acceptable — it is a calculation, not a rule of thumb.
Yes, in both 2-conductor and 4-conductor builds.
Send the run lengths, environment and device loading for your public address & av systems project. We will name the stocked specification that fits before you order rather than after.