How to Get a Longer Service Life From Layflat Hose

Abrasion Is the Real Life Limit

Cover wear, not burst pressure, is what ends most hose lives. Protect the run where it crosses vehicle routes, keep it off sharp aggregate, and roll it out rather than dragging it charged. Abrasion resistance is tested on material samples in our own test centre before production.

See the Canvas Discharge Hose

Dry Before You Roll

Woven jacket hose stored damp is vulnerable to mildew. Rubber covered hose is the exception, because the nitrile cover is fungus resistant and never needs drying, which is the practical reason fire services choose it for fleet use.

See the Rubber Covered Fire Hose

Roll, Do Not Fold

A hose folded at the same point every time develops a permanent crease, and the crease becomes the failure. Roll from one end, store rolls on a rack rather than stacked flat under load, and rotate which lengths get deployed so wear is spread across the fleet.

See the Layflat Discharge Hose

Fit Clamps Where the Wall Can Take Them

On helix suction hose the clamp seats between helix turns. On layflat hose the coupling must match the actual hose outside diameter. A clamp in the wrong place damages the wall it is meant to seal against.

See the Fabric Reinforced Suction Hose

Use the Trace Number

Every Jason hose carries a trace number covering production date, production employees and raw material sources. Recording which hose went where turns a field failure from an argument into an investigation, and lets a fleet be rotated on evidence rather than guesswork.

See the Mine Dewatering Hose