Home / Knowledge Centre

Knowledge Centre

Buying guides, comparisons and installation notes written from the same specification tables that appear on our product pages.

Our three casing materials share one dimensional specification: OD 70 plus minus 1.0 mm, wall 5 plus minus 0.5 mm,...

A traversing probe is lowered through the casing to build a full profile on each visit. An in place string stays in the...

AT-LC-2020 is supplied in ten steps from 0.1 MPa to 6.0 MPa. AT-LC-2030, the strain type micro cell, covers 0 to 1.0...

A 0.10 mm harness film and a 0.15 mm electrical tape solve different problems. Thin film keeps bundle diameter down;...

Clean and abrade the area before application. Most joint failures we are asked about start with contamination under the...

Filling cells with local soil, gravel or concrete creates lateral restraint, which spreads load and reduces rutting...

Questions Buyers Ask

About These Guides

Where does the technical data in these articles come from

From our own published product specifications. Where a value is quoted, it appears in the specification table of the product the article links to.

Can you advise on a specific installation

Yes. Send the details on WhatsApp and we will answer against the product data rather than in general terms.

Do you publish datasheets

Full specifications are published on each product page and can be sent as a document on request.

If an article does not answer your case, send the detail and we will answer against the product data.