Fuse Cutout Bushings
Porcelain bodies and complete drop-out fuse cutouts for pole-mounted transformer protection from 10kV through 33kV.
Problems this range solves
What Buyers Come To Us With
- Fault levels above what the installed cutout can safely break
- Faults that cannot be located visually from the ground
- Cutout bodies that do not match the installed figure number
- Mixed brands of cutout across a network with no common specification
Core advantages
What The Range Gives You
- RW11-10/100 and RW11-10/200 ratings at 6.3kA and 12.5kA breaking current
- Fifteen porcelain figure numbers spanning 220mm to 660mm creepage
- 110kV BIL with 42kV power frequency withstand on the 10kV cutouts
- Built to IEC safety standards, with ANSI and AS figures also covered
Who it is for
Suited To
- Distribution utilities protecting pole transformers
- Cutout assemblers sourcing porcelain bodies
- Rural electrification contractors
Application scenarios
Where It Is Used
- Pole-mounted transformer protection
- Rural feeder sectionalising points
- Networks needing visible fault indication
- Distribution network refurbishment
Industries
Industries We Supply With This Range
Questions
Fuse Cutout Bushings Questions
What cutout ratings do you supply?
RW11-10/100 at 10kV and 100A with 6.3kA breaking current, and RW11-10/200 at 10kV and 200A with 12.5kA breaking current.
What creepage distances are available on the porcelain bodies?
From 220mm up to 660mm across fifteen published figure numbers covering 15kV, 25kV, 24/27kV and 33/36kV classes.
What safety standard applies?
IEC.
Can you supply under our own brand?
Yes, brand name is as per customer requirements and model numbers can be ordered to your reference.
How should I choose the rating?
From the fault level at the installation point, not from the transformer size alone.
Talk To An Engineer About Fuse Cutout Bushings
Send the drawing, the pollution class at the site, or a photograph of the part you are replacing. A reply comes back within 24 hours.