Guides to Specifying Steel Hardware
Nine guides built around our own size ladders, finishes and inspection flow. Every figure quoted is one we publish on a product page, so you can check it against the specification.
How to Choose a Shelf Bracket Size and Thickness
Bracket sizes are quoted as wall leg x shelf leg x material thickness. This guide explains how to read that notation, how to match it to a shelf board, and where the gauge steps up in our range.
Shelf Bracket Finishes Compared White Grey Black Zinc and Galvanized
Powder coat, zinc plating, brass and nickel plating and hot dip galvanizing all appear across our range. Each one fails in a different way, which is what should decide the choice.
Corner Brace vs Mending Plate Which Reinforcement to Use
Both parts reinforce a joint, and they are not interchangeable. The choice is decided by the geometry of the joint, not by which one is stronger.
Barrel Bolts Safety Hasps and Latches Explained
Three families of door hardware that are often specified interchangeably and should not be. What each one actually secures, and where each one fails.
Choosing a Gate Latch for Out-Swing Gates and Animal Pens
An automatic latch closes itself. That single difference is why it belongs on a livestock gate and a manual drop latch does not.
Steel Pallets vs Plastic and Wooden Pallets
Timber is the cheapest pallet to buy and the most expensive to certify. Plastic is clean until it cracks. The case for steel is made over the life of the fleet, not at the first invoice.
How Dismountable Steel Pallets Cut Freight Cost
An assembled pallet is mostly air. The dismountable design is what makes importing steel pallets economic rather than theoretical.
A Buyer Guide to OEM and Private Label Hardware
What to settle before a private label hardware programme starts, and which of those decisions carry a tooling cost.
Inside Our Inspection Flow From Incoming Steel to Delivery
Seven checkpoints between the steel arriving and the carton leaving, and the one rule that decides whether a lot is repaired or stopped.
Before You Read Further
Are you a trading company or a factory?
We are a factory.
Could you provide OEM or ODM service?
Yes. We can produce to your specification or design according to your request.
Why should I consider you? What is your strength?
Three things. No hassles, because we are easy to communicate with. No delays, because we are flexible with production scheduling. No risks, because we are detail-oriented and take care of every one of your quality needs.
Do you have a minimum order quantity?
Yes, we have a very small minimum order quantity and the quantity can be negotiated.
Something Not Covered Here
Send the question with the model number and we will answer it directly rather than pointing you at a brochure.