Carbide Rings
Carbide Seal Rings
Fully machined and grinding rings for mechanical seals and rolling wear positions
Product Detail
Product Category
Tungsten Carbide Rings and Roll Rings
Tungsten carbide rings supplied as grinding rings fully machined rings and segment sets where one carbide ring and four segments make one set. Used as mechanical seal rings and rolling wear rings.
Problems It Solves
What Goes Wrong Today
- Seal faces in chemical and petroleum duty score and start to leak
- Roll surfaces wear oval and the strip or wire loses dimensional control
- Large diameter rings are difficult to source in one piece
Benefits
What Changes With Carbide
- Ring plus four segments as one set simplifies assembly and spare part holding
- Fully machined rings arrive ready to fit with ground bore and faces
- Grinding rings can be supplied for customers who finish in their own shop
Types We Produce
Forms in This Category
- Grinding carbide rings
- Fully machined carbide rings
- Ring and segment sets with 1 ring and 4 segments per set
- Mechanical seal rings
Grades tolerances and dimensions are confirmed against your drawing when you enquire.
Product Photographs
Carbide Rings in Production
These are photographs of parts produced in our own plant. Each caption describes what the picture actually shows.
Application Scenarios
Industries That Use This Category
Keep Reading
Related Cases and Guides
Carbide Sleeve With 176 Holes
A carbide sleeve of OD 268 mm x ID 228.6 mm x H 160 mm carrying 176 holes produced for oil field service equip…
Read MoreCarbide Strips up to 1800 mm
Carbide strip production where the standard length is 330 mm and the maximum length produced in one piece is 1…
Read MoreTungsten Carbide Grade Guide
How cobalt content and grain size move hardness against toughness and how to describe your application so a su…
Read MoreSinter-HIP Process Guide
The production route from WC powder through ball milling spray drying pressing Sinter-HIP and machining and wh…
Read More
FAQ
Carbide Rings FAQ
Which industries buy carbide rings from you?
Mainly Petroleum and Gas, Metal Forming and Wire Drawing, Paper Printing and Packaging. Tell us your application and we will confirm what suits it.
Can you produce carbide rings to our drawing?
Yes. Custom made carbide parts to drawing are a normal part of our production. Send the drawing or a measured sample and we will confirm what is manufacturable in carbide.
What material are these parts made from?
Cemented tungsten carbide which is tungsten carbide grain in a cobalt binder. The grade direction is chosen with our engineers against your load case rather than sold as one universal grade.
How are the parts densified?
Blanks are densified by Sinter-HIP which applies isostatic gas pressure during the sintering cycle so residual porosity is reduced before machining.
What do you need in order to quote?
The drawing or a sketch with measured dimensions the quantity and a short description of the application. Send it on WhatsApp to +86 187 7492 5813 or by email to [email protected].
Next Step
Get a Quotation for Carbide Rings
Send the drawing the quantity and a short note about the application. Our engineers reply with a specification you can check before ordering.
Send a drawing or a sample photo on WhatsApp or by email. Files are reviewed by our production engineers, not by a form.