Carbide for Oil Industry
Carbide Sleeves
Large carbide sleeves with drilled hole patterns including 176 hole and 82 hole designs
Product Detail
Product Category
Tungsten Carbide Parts for the Petroleum Industry
Tungsten carbide sleeves cores seats shaft sleeves drilling bushes flow beans tubes and valve cores for oil exploration and well completion equipment.
Problems It Solves
What Goes Wrong Today
- Abrasive well fluid erodes steel sleeves and bushings within one run
- Erosion changes flow geometry and the pump stops holding pressure
- A failed downhole wear part costs far more in intervention than in material
Benefits
What Changes With Carbide
- Carbide sleeves keep the bore geometry stable in abrasive service
- Complex hole patterns such as 176 holes in one sleeve are produced in house
- Parts are produced to your drawing including bore tolerance and hole layout
Types We Produce
Forms in This Category
- Carbide sleeves with drilled hole patterns
- Carbide cores
- Carbide seats
- Carbide oil shaft sleeves drilling bushes flow beans and valve cores
Grades tolerances and dimensions are confirmed against your drawing when you enquire.
Product Photographs
Carbide for Oil Industry in Production
These are photographs of parts produced in our own plant. Each caption describes what the picture actually shows.
Application Scenarios
Industries That Use This Category
Keep Reading
Related Cases and Guides
Carbide Sleeve With 176 Holes
A carbide sleeve of OD 268 mm x ID 228.6 mm x H 160 mm carrying 176 holes produced for oil field service equip…
Read MoreAPI V11 Valve Pair Supply
Tungsten carbide ball and seat valve pairs in the API V11 series produced for subsurface oil well pumps togeth…
Read MoreTungsten Carbide Grade Guide
How cobalt content and grain size move hardness against toughness and how to describe your application so a su…
Read MoreSinter-HIP Process Guide
The production route from WC powder through ball milling spray drying pressing Sinter-HIP and machining and wh…
Read More
FAQ
Carbide for Oil Industry FAQ
Which industries buy carbide for oil industry from you?
Mainly Petroleum and Gas, Mining and Drilling. Tell us your application and we will confirm what suits it.
Can you produce carbide for oil industry to our drawing?
Yes. Custom made carbide parts to drawing are a normal part of our production. Send the drawing or a measured sample and we will confirm what is manufacturable in carbide.
What material are these parts made from?
Cemented tungsten carbide which is tungsten carbide grain in a cobalt binder. The grade direction is chosen with our engineers against your load case rather than sold as one universal grade.
How are the parts densified?
Blanks are densified by Sinter-HIP which applies isostatic gas pressure during the sintering cycle so residual porosity is reduced before machining.
What do you need in order to quote?
The drawing or a sketch with measured dimensions the quantity and a short description of the application. Send it on WhatsApp to +86 187 7492 5813 or by email to [email protected].
Next Step
Get a Quotation for Carbide for Oil Industry
Send the drawing the quantity and a short note about the application. Our engineers reply with a specification you can check before ordering.
Send a drawing or a sample photo on WhatsApp or by email. Files are reviewed by our production engineers, not by a form.