Tungsten carbide die blanks produced for metal forming

Industry Application

Tungsten Carbide for Metal Forming and Wire Drawing

Carbide plugs and dies for tube making dies for hot and cold extrusion and metal forming extrusion dies for container making blanks for lamination dies tooling for the dry cell battery industry and bar drawing dies for ferrous and non ferrous bars.

Industry Pain Points

What Fails in This Sector

Die cavities wear open and the formed section drifts out of tolerance
Frequent die changes cost a press setup and a batch of scrap
Cracks start at porosity left after conventional sintering
Drawn wire and bar lose dimensional control before the shift ends

Customer Needs

What Buyers Actually Need

Dies that keep the working bore stable over long runs
Densified material that resists crack initiation under repeated load
Blanks for in house tool rooms and finished dies for those without one
Bore geometry produced exactly as the drawing specifies

Where the Parts Are Used

Cold extrusion of fasteners and bolts
Hot forging dies for engine valve production
Bar drawing for ferrous and non ferrous material
Plugs and dies for tube making and lamination die blanks
Ball heading and taper roller heading for the bearing industry

Delivery Capability

What We Can Deliver

Sinter-HIP densification before machining
Grinding lapping and EDM finishing
Die blanks or finished dies to drawing
Dimensional inspection with calipers and gauges before packing

Solution Flow

Solution Route for Metal Forming and Wire Drawing

1. Requirement ReviewDrawing sample or failure photos reviewed by an engineer

2. Grade DirectionAbrasion or impact dominated load case discussed with you

3. Drawing ApprovalGeometry and critical dimensions agreed in writing

4. ProductionPressing Sinter-HIP and machining to the approved drawing

5. InspectionCritical dimensions checked before packing

6. Export DeliveryProtected packing and documents for your clearance

Cases and Knowledge for This Industry

Carbide Sleeve With 176 Holes

A carbide sleeve of OD 268 mm x ID 228.6 mm x H 160 mm carrying 176 holes produced for oil field service equip…

Carbide Die Design Guide

Design rules that decide whether a carbide die or wear part can actually be pressed ground and put into servic…

Sinter-HIP Process Guide

The production route from WC powder through ball milling spray drying pressing Sinter-HIP and machining and wh…

Tungsten Carbide Grade Guide

How cobalt content and grain size move hardness against toughness and how to describe your application so a su…

FAQ

Metal Forming and Wire Drawing FAQ

Which carbide products do you recommend for metal forming and wire drawing?

Mainly Carbide Cold Forming Dies, Carbide Forging Dies, Carbide Tubes and Bushes, Carbide Gears. The right one depends on the geometry and the failure mode so send a drawing or photos of the worn part.

Can you match a part we currently buy elsewhere?

Yes if you send the drawing or a measured sample. We prepare a drawing for your approval before production and we do not copy from photographs alone.

What information helps you quote quickly for this sector?

The drawing the quantity the operating conditions and how the current part fails. Send it on WhatsApp to +86 187 7492 5813 or by email to [email protected].

Do you supply sample quantities first?

For critical applications a sample run before the production order is the honest way to confirm both the grade and the geometry. Ask for it when you enquire.

Next Step

Get a Carbide Solution for Metal Forming and Wire Drawing

Send the drawing or photos of the worn part with measured dimensions. Our engineers reply with a direction you can evaluate.

Chat on WhatsApp Email Us View All Products

Send a drawing or a sample photo on WhatsApp or by email. Files are reviewed by our production engineers, not by a form.