Energy and Environmental Industry
Weighing of coal and biomass pellets, and dosing and metering of lime and activated carbon in wastewater treatment processes.
Request A QuoteWhat This Industry Actually Struggles With
Treatment chemical overdosing is a direct operating cost, underdosing is a compliance failure
Lime and activated carbon are dusty, cohesive and hard to meter consistently
Fuel weighing figures have to stand up as a fuel cost and an emissions input at the same time
Dosing equipment that is not networked leaves the plant without a usable consumption record
Where Our Equipment Is Installed
- Dosing lime into a wastewater neutralisation stage
- Metering activated carbon into a treatment line
- Weighing coal and biomass pellets on the fuel handling route
- Recording cumulative consumption totals back to the plant control system
Machines That Fit This Duty
High-Precision Feeder
A screw feeder, a hopper weighing unit and a control unit working as one loop. The controller reads material weight and screw speed in real time,…
View Specifications
Automatic Discontinuous Totalizing Hopper Weigher
A batch totalising scale for in-plant metering. Material fills a weighing hopper, the weight is recorded, the hopper discharges and the controller…
View Specifications
Dust Collector
A fan pulls dust-laden air away from the charging point, cartridge filters intercept the particles, clean air is exhausted and the collected dust…
View SpecificationsWhere Else These Machines Run
FAQ For Energy and Environmental Industry
Can dosing rate be controlled continuously rather than in batches?
Yes. The feeder offers continuous flow quantitative control as well as batch cumulative quantitative control, so the mode can follow the process.
Do you provide cumulative totals to the control system?
The control units transmit real-time measurement data to the host and accept host commands through a digital interface and command set.
How do you handle dust from lime and carbon charging?
With a cartridge dust collector at the charging point, which draws dust-laden air under negative pressure and returns recovered material to the hopper.
Discuss a Energy and Environmental Industry Application
Tell us the material, the stage in the process and the accuracy the specification demands.