Knowledge Centre

6 guides on the decisions that are cheap to get right at drawing stage and expensive to correct once a container has landed.

The four panel materials used across the Sayea range, what each one is actually good at, and where buyers routinely specify the wrong one.

Knockdown, RTA and flat pack describe the same idea from three angles. What the construction changes for damage rates, freight and site work.

Length, extension, closing action and material - the four decisions behind a drawer runner, worked through against the 45 mm three fold silent slide.

Why the shaker door outsells every other profile in export kitchen programmes, and how paint veneer and solid timber versions differ.

The measurements a cut list actually needs, why three width readings matter, and the site conditions that ruin an otherwise correct order.

Wheel material, stem fitting and load - why the wrong caster marks a new floor, and how to check a replacement will actually fit.

Still Not Sure How To Specify It

The guides cover the general case. For your actual room, wall or drawer schedule, send the numbers and get a specific answer.