Electrical Contracting And Installation
Contractors judge a tool by whether it costs them a second trip. The wiring accessories and hand tools in this range are the ones that decide whether a first fix goes in cleanly.
What Goes Wrong
- A steel fish tape cannot enter duct that already carries live conductors, so the crew stops work
- Tapes corrode in damp risers and then bind inside the conduit
- A distribution board arrives with the wrong number of ways and the job waits
- Junction boxes that do not hold out water fail outdoors and the contractor goes back at their own cost
- Cheap connectors and terminals loosen and cause callbacks that cost more than the part
What This Buyer Needs
- Non-conductive cable pullers for work in occupied duct
- Enough length options that one van kit covers short domestic and long service runs
- Distribution boards in the way counts the local trade actually installs
- Waterproof junction boxes and connectors for outdoor and damp locations
- Terminals and busbars that stay tight after the panel warms and cools
Recommended Lines
Nylon Cable Puller (Catalogue Item 2 Of 2)
View Product
Fiberglass Electrical Connectable Fish Tape
View Product
Steel/Metal Cable Puller
View Product
Distribution Board Electrical Boxes 4/6/8/12Ways
View Product
Bending Spring
View Product
Waterproof Isolator
View ProductTypical Scenarios
- First fix and rewiring in residential and light commercial buildings
- Running network, phone and speaker cable through walls and ceilings
- Outdoor and site wiring where boxes and connectors are exposed to weather
- Panel assembly and consumer unit replacement
- Maintenance work where the duct is already occupied
From Enquiry To Delivery
Tell us the job type and the local installation standard you work to
We suggest the tape material and length range that suits your typical run
Samples confirm the feel of the tool before a crew standardises on it
Repeat orders are matched to the same specification so the van kit stays consistent
What We Supply Into This Industry
- Several tape materials and lengths so one supplier covers the whole van kit
- Distribution boards in 4, 6, 8 and 12 way and customised counts
- Waterproof junction boxes and connectors in the same order as the tools
- Sample supply before a crew standardises on a tool
Related Reading
Steel Fiberglass Or Nylon Which Fish Tape To Stock
The three fish tape materials are not competing versions of the same tool. Each one exists because the other two fail in a specific situation. This is how to decide which belongs in your range.
Read GuideChoosing A Waterproof Junction Box For Outdoor Wiring
Outdoor connections fail at the box before they fail at the cable. What to look at when you are selecting an enclosure range to stock.
Read GuideWiring Quick Connectors Versus Twisted And Taped Joints
Why lever and push-in connectors have taken over from twisted joints, and where the old method still hangs on.
Read GuideElectrical Contracting And Installation Questions
Which cable puller is safe in duct that may still be live?
The nylon cable puller. Its tape is specified as non-conductive, which is the reason it exists alongside the steel version. Normal isolation practice on site still applies.
Do you supply small quantities for a single crew?
Our normal business is wholesale, so the practical route for a single crew is through a distributor stocking our lines. If you are buying direct, tell us what you need and we will tell you honestly whether the quantity works.
Can we get distribution boards in a way count that is not standard?
The distribution board is listed in 4, 6, 8 and 12 way, and other counts can be customised. Send the layout you need.
Supplying Electrical Contracting And Installation
Send your list and quantities and we will tell you what we can cover and what we cannot.