Factory Tour
Parts store, machining and assembly floor and the pump test bench. Every photograph on this page is from the factory.
Where the Pumps Are Built
Castings come in, are machined under the overhead cranes, are staged through the parts store and go out as complete tested sets.
What the Photographs Show
Parts Held in Stock
Multi level racking across the length of the building holding castings, rotating assemblies and spare parts.
In House Machining
Machining bays served by overhead travelling cranes, with finished casings and impellers laid out on the floor.
Staged Assembly
Shelved and binned components brought to the assembly area rather than picked from the machine.
Bench Testing
Pump sets coupled up on the test bed with suction and discharge lines connected and run before packing.
From Casting to Packed Pump Set
Casting Intake
Casings and impellers received and booked into the store.
Machining
Faces, bores and shafts machined to the drawing.
Staging
Parts and hardware kitted for the order.
Assembly
Rotating element built, casing closed, set aligned on the baseplate.
Test and Pack
Run on the bench, then packed for shipment.
Factory Questions
Can I visit the factory
Send us a message with your dates and the products you are interested in and we will arrange the visit.
Are the pumps tested before shipment
The test bench in the photographs is where pump sets are coupled up with suction and discharge lines connected and run.
Do you hold parts in stock
The parts store shown here holds castings, rotating assemblies and spare parts across the ranges.
Is machining done in house
Yes. The machining bays with overhead travelling cranes are shown on this page.
Come and See the Plant
Tell us when you are travelling and which series you want to see on the floor.