O Belt Roller Bearings
Plastic O Belt Roller Bearings for 50mm or 60mm tube diameter with shaft sizes of 12mm or 15mm, designed to fit directly onto standard conveyor tubes and support belt-driven roller systems.
Problems It Solves
- Belt rollers that need to run on standard 50mm or 60mm diameter tubes without custom machining
- Need for a plastic end cap that reduces noise and wear on the belt without damaging the tube
- Replacing metal end caps that cause belt tracking issues or tube wear over time
- Mounting bearings on tubes where a press fit or threaded shaft is not feasible
- Using a consistent end cap design across multiple belt roller units in a conveyor line
Who It Is For
- Conveyor system integrators building belt conveyors with standard tube sizes
- Material handling equipment builders requiring plastic end caps for noise reduction
- Assembly line builders using belt rollers with 50mm or 60mm tubes
- Industrial distributors stocking end caps by tube diameter and shaft size
- Warehouse automation contractors installing belt conveyors with consistent roller ends
Why This Range
- Designed for 50mm or 60mm tube diameter with shaft sizes of 12mm or 15mm
- Plastic housing made from Nylon66 for low wear and noise on belts
- Bearing type 6804*2 for 15mm shaft, 6002*2 for 12mm shaft, matched to shaft size
- Direct fit onto standard tube sizes without additional machining
- Consistent design across both 12mm and 15mm shaft variants for same tube diameter
Application Scenarios
- Belt conveyors in packaging lines where noise must be minimized
- Assembly lines using belt rollers with 50mm or 60mm tubes and 12mm or 15mm shafts
- Material handling systems where plastic end caps prevent tube damage
- Conveyor sections where belt tracking is affected by metal end cap friction
- Replacement of worn metal end caps with plastic units on existing belt roller systems
Where To Go Next
Industries
- Warehouse and production lines
Selection Guides
- See the solutions pages
Knowledge Center
O Belt Roller Bearings Questions
What tube diameters do these end caps fit?
They fit 50mm or 60mm diameter tubes, with specific models for each size.
Which shaft sizes are available?
Available shaft sizes are 12mm and 15mm, each with matching bearing and housing.
What material is used for the end cap?
The end cap is made from Nylon66, providing low wear and noise on belts.
What bearings are used in each model?
15mm shaft uses 6804*2 bearings, 12mm shaft uses 6002*2 bearings.
Can I use these on both 50mm and 60mm tubes?
Yes, each model is specified for either 50mm or 60mm tube diameter.
Do the end caps require machining to fit?
No, they are designed to fit standard 50mm or 60mm tubes without modification.
Are there different models for different shaft sizes?
Yes, separate models are available for 12mm and 15mm shafts with matching bearings.
Quote O Belt Roller Bearings Against Your Model List
Send the models and quantities you need, or the dimensions of the line you are building, and a quotation comes back on those figures.