SpO2 Sensor 9 Pin for Masimo K2131 LNCS Series 0.9M

Product Overview

It is documented as compatible with monitors from CAS Med, Datex, Draeger, GE, GE and Critikon and 12 further manufacturers, with the exact monitor models listed in the compatibility table below. The series carries 8 part numbers covering finger clip, silicone soft tip, neonatal silicone wrap, multi-site Y type, ear clip and veterinary animal clip variants in adult, pediatric and neonatal sizes. The sensor uses Masimo SpO2 technology, which is the technology the listed monitors expect. Standard housing colour is gray or blue. Warranty is 6 months.

These are SpO2 Sensors 9 Pin compatible for Masimo 1863, Mindray, Philips, GE.

Problems It Solves

In a two-part system the expensive half is the extension cable that stays with the monitor, and the half that gets damaged is the probe on the patient. Short sensors let you replace only the damaged probe, so the cost of a drop or a crushed clip is a fraction of a full one piece sensor.

For this item specifically: the part exists so a Masimo monitor already in service can keep being used when its original probe is damaged or discontinued.

Who It Is For

This part suits departments monitoring adult, pediatric and neonatal patients, anyone running Masimo monitors and distributors holding stock against a mixed monitor fleet.

• Wards already standardised on extension adapters
• Transport and ambulance monitors
• Day surgery and dental
• High-turnover departments replacing probes often

Specifications

Every figure below is taken from the product documentation for this item. Where a value is not published we mark it TBC rather than estimating it.

Model Numbers in This Series

Every variant below is a separate part number within the same series. Quote the code that matches the patient size and probe style you need.

Monitor Compatibility

This part is built for the monitors listed below, taken from our product documentation. A matching plug shape alone does not guarantee a matching signal, so confirm your exact model here before ordering.

Quality Control

This part is produced under our ISO 13485 quality management system with compliance to CE Mark and FDA regulations. It passes three inspection stages: IQC on the incoming connectors, wires, cables and terminals; IPQC through cutting, stripping, crimping, injection and assembly; and OQC on packing, labels, marks, appearance, dimensions and electrical performance before it is released.

Customisation Options

Cable length on this item is stated as 0.9M or Customized, so a non-standard length can be quoted. Under our OEM and ODM service the product features, branding, packaging and labelling are customised, and we handle the regulatory documentation for your target market.

Comparison With the Alternatives

Against a one piece sensor, this short build costs less to replace because the extension adapter stays on the monitor, at the price of one extra connection in the chain. Against a disposable sensor it is reusable but needs cleaning between patients.

Use Guide

1. Confirm the monitor manufacturer and model against the compatibility table above.
2. Check the connector on the monitor matches 9 Pin Male.
3. Choose the patient size and probe style from the model table, then quote that part number.
4. Apply the sensor to a clean, well-perfused site and keep the emitter and detector aligned opposite each other.
5. Rotate the measurement site regularly on long recordings to protect skin integrity.
6. Between patients, clean and disinfect reusable items under your own protocol; discard single-patient-use items.